Новини
Gábor Ulicska
притежава кита
притежава кита
SB2C-4 Helldiver Mainwheels Set for Academy, Airfix, Special Hobby
CMK (Czech Master Kits) 1:72
7369 2017 Нова матрица 21 July, 20:15
Dave Norman
добави нов фотоалбум.
добави нов фотоалбум.
1 21 July, 20:05
Dave Norman
Photos of the completed model before I start work on the base. Eduard's 1/48th "Desert babe" plus additional accesories from Eduard including, AIM-7s, Boz pod, Skyshadow pod, paveways. Also added Master's pitot probe and some 3d printed intake and exhaust blanks purchased from a nice chap on Ebay. Paints used were mostly MRP-243 US Desert Sand (FS30279) with some MRP-185 Desert Pink RAF used to post shade and add some variation.
Photos of the completed model before I start work on the base. Eduard's 1/48th "Desert babe" plus additional accesories from Eduard including, AIM-7s, Boz pod, Skyshadow pod, paveways. Also added Master's pitot probe and some 3d printed intake and exhaust blanks purchased from a nice chap on Ebay. Paints used were mostly MRP-243 US Desert Sand (FS30279) with some MRP-185 Desert Pink RAF used to post shade and add some variation.
21 July, 20:13
Alec K
притежава кита
притежава кита
Czechoslovak pre-WWII pilots (3 fig)
CMK (Czech Master Kits) 1:72
F72325 21 July, 20:12
Alec K
притежава кита
притежава кита
Marder Tank Destroyer Commander and Gunner
CMK (Czech Master Kits) 1:72
F72400 21 July, 20:11
Alec K
притежава кита
притежава кита
Avia S-199 Pilot and Mechanic / for Eduard and other kits
CMK (Czech Master Kits) 1:72
F72385 21 July, 20:11
David Smith
добави нов фотоалбум.
добави нов фотоалбум.
46 30 June, 11:44
David Smith
I hadn't seen Konrad's build! I'm not promising the same attention to detail.
I hadn't seen Konrad's build! I'm not promising the same attention to detail.
30 June, 20:38
David Smith
Thanks everyone for your generous comments. The kit is a bit fiddly in places - lots of thin struts and no location points - so I wouldn't recommend it for beginners. However, I must say that the finished result is all I could have hoped for. The 'look' of the finished article is just what I wanted and I thoroughly enjoyed building it. The canopy masking set and resin missile system were superb. The decals too, although I only needed a tiny proportion of what was on the sheet.
Thanks everyone for your generous comments. The kit is a bit fiddly in places - lots of thin struts and no location points - so I wouldn't recommend it for beginners. However, I must say that the finished result is all I could have hoped for. The 'look' of the finished article is just what I wanted and I thoroughly enjoyed building it. The canopy masking set and resin missile system were superb. The decals too, although I only needed a tiny proportion of what was on the sheet.
21 July, 20:10
Alec K
притежава кита
притежава кита
RAF Pilot Sitting in Cockpit w/Monkey on Shoulder + 2 Mechanics, Western Desert
CMK (Czech Master Kits) 1:72
F72344 2018 Нова матрица 21 July, 20:10
Alec K
притежава кита
притежава кита
German WWII personnel for Meillerwagen V2 transporter Special Armour
CMK (Czech Master Kits) 1:72
F72304 2016 Нова матрица 21 July, 20:10
Alec K
притежава кита
притежава кита
Afrikakorps Soldier Riding Camel 3D Printed
CMK (Czech Master Kits) 1:72
F72388 (129-F72388) 2023 Нова матрица 21 July, 20:09
nikfrost
добави нов фотоалбум.
добави нов фотоалбум.
13 27 April, 16:38
nikfrost
Thanks Bozzer! I think I'm getting the hang of this gloss finish also...hopefully.
Thanks Bozzer! I think I'm getting the hang of this gloss finish also...hopefully.
8 July, 20:23
Mr D
Nice 👍 very nice, the cast texture on the engine looks good, it's the prv V6 is it ?
I had an RC version as a kid .
Will look fantastic when the decals go on.
👌
Nice 👍 very nice, the cast texture on the engine looks good, it's the prv V6 is it ?
I had an RC version as a kid .
Will look fantastic when the decals go on.
👌
12 July, 20:58
nikfrost
The cast texture is Tamiya flat aluminium XF-16 very poorly sprayed by me haha, I think it was drying on its way from the airbrush to the surface and kind of built up.
The cast texture is Tamiya flat aluminium XF-16 very poorly sprayed by me haha, I think it was drying on its way from the airbrush to the surface and kind of built up.
12 July, 21:26
Mr D
Worked well to the effect 👍 Tamiya dries really fast , l use Velejo mostly, l found Tamiya to fast n thickens up in the pot, Velejo doesn't harden like Tamiya n definitely needs good clear coat.
Nice project 👍
Worked well to the effect 👍 Tamiya dries really fast , l use Velejo mostly, l found Tamiya to fast n thickens up in the pot, Velejo doesn't harden like Tamiya n definitely needs good clear coat.
Nice project 👍
14 July, 16:14
nikfrost
I always put a dollop of tamiya lacquer thinner in and two mixing balls, seems to keep it moving quite well.
I always put a dollop of tamiya lacquer thinner in and two mixing balls, seems to keep it moving quite well.
14 July, 21:12
Rob K.
добави нов фотоалбум.
добави нов фотоалбум.
2 21 July, 19:26
Rob K.
The scale is 1/48. I am new to scalemates. Just joined. Trying to find this post. Under which header/subject are you able to see this album? I am unable to find this post where everyone can see it. Thanks
The scale is 1/48. I am new to scalemates. Just joined. Trying to find this post. Under which header/subject are you able to see this album? I am unable to find this post where everyone can see it. Thanks
21 July, 20:08
/bg/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=bg
35
35
/bg/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo