Новини
Panzerjäger Hantoeig
притежава кита
притежава кита
30MM / 30Minutes Missions
eEXM-9 Baskyrotto (Brown)Bandai Spirits 1:144
5066379 (62) 2024 Нова матрица 14 October, 04:43
Loginthesand
търси този кит
търси този кит
HGUC Gundam Unicorn
AMS-129 Geara Zulu (Angelo Sauper Use) Neo Zeon Mass-Produced Mobile Suit Bandai Spirits 1:144
5063850 (112) 2022 Нова кутия 14 October, 04:43
★ Starfish ★
добави нов фотоалбум.
добави нов фотоалбум.
68 8 March, 15:53
★ Starfish ★
Here's the first update on a project I recently completed. This build was particularly meaningful to me for a few reasons. Firstly, the F-22 is one of my all-time favorite aircraft. I've had this kit for several years, but I've always been hesitant to start building it due to the challenging paint job required for the Raptor. Luckily, and that's the second reason why this is so special to me, my loyal follower Marie asked me to build a Raptor for her. Since I was currently in between projects, I just started building right away and surprisingly the end result turned out better than expected. Most importantly, Marie is thrilled with the model I sent her!
Below you can see the pilot figure I painted just because I think aircraft in flight without a crew look odd. As far as I know, Raptor pilots are not equipped with JHMCS helmets but that's just a minor detail I decided to overlook given the small scale. More updates will follow as I'm currently working on a video showcasing the building and painting process in detail.
Here's the first update on a project I recently completed. This build was particularly meaningful to me for a few reasons. Firstly, the F-22 is one of my all-time favorite aircraft. I've had this kit for several years, but I've always been hesitant to start building it due to the challenging paint job required for the Raptor. Luckily, and that's the second reason why this is so special to me, my loyal follower Marie asked me to build a Raptor for her. Since I was currently in between projects, I just started building right away and surprisingly the end result turned out better than expected. Most importantly, Marie is thrilled with the model I sent her!
Below you can see the pilot figure I painted just because I think aircraft in flight without a crew look odd. As far as I know, Raptor pilots are not equipped with JHMCS helmets but that's just a minor detail I decided to overlook given the small scale. More updates will follow as I'm currently working on a video showcasing the building and painting process in detail.
11 March, 18:51
Matt L
Would love to see more Raptor kits with other paint schemes and decals not requiring an air brush
Would love to see more Raptor kits with other paint schemes and decals not requiring an air brush
21 March, 19:10
★ Starfish ★
@Matt Well, I don't know of any other paint schemes for Raptors other than the standard and chrome schemes! However, it's always up to you how you want to paint your model 🙂
@Matt Well, I don't know of any other paint schemes for Raptors other than the standard and chrome schemes! However, it's always up to you how you want to paint your model 🙂
21 March, 19:34
Matt L
Like to keep it authentic with decals and paint schemes - maybe we will see different paint design with a new future F-22 variant (if it happens). Many 5th gen jets seem to get pretty advance schemes where detailed airbrushing may be the best option though.
Like to keep it authentic with decals and paint schemes - maybe we will see different paint design with a new future F-22 variant (if it happens). Many 5th gen jets seem to get pretty advance schemes where detailed airbrushing may be the best option though.
22 March, 08:18
CaptGPF
Sadly, I doubt we are going to see any variants - as the production lines have been shuttered for quite a while - and the USAF cancelled any new block upgrades in favor of the NGAD program. Outside of the Tomcat, I felt that the Raptor was a rare no-compromise aircraft built for total air dominance. I'm interested in seeing how you tackle the metallic coloring for this bird. I'd also love to see your comments on the pictures! 😀
Sadly, I doubt we are going to see any variants - as the production lines have been shuttered for quite a while - and the USAF cancelled any new block upgrades in favor of the NGAD program. Outside of the Tomcat, I felt that the Raptor was a rare no-compromise aircraft built for total air dominance. I'm interested in seeing how you tackle the metallic coloring for this bird. I'd also love to see your comments on the pictures! 😀
27 April, 16:57
★ Starfish ★
More pics will be added over time. Here's my video about the build: Youtube Video
More pics will be added over time. Here's my video about the build: Youtube Video
8 May, 20:50
★ Starfish ★
Thanks Vincent! I took a lot of inspiration from the painting process on your excellent Raptor!
Thanks Vincent! I took a lot of inspiration from the painting process on your excellent Raptor!
9 May, 09:04
Loginthesand
търси този кит
търси този кит
HGUC Gundam 0083
AGX-04 Gerbera-Tetra Delaz Fleet Assault Use Prototype Mobile Suit Bandai Spirits 1:144
5055886 (159) 2019 Нова кутия 14 October, 04:41
Loginthesand
търси този кит
търси този кит
HGUC Gundam Unicorn
RX-160S Byarlant Custom E.F.F. Prototype Mobile Suit Bandai 1:144
0178533 (147) 2012 Нова матрица 14 October, 04:39
Loginthesand
търси този кит
търси този кит
High Grade (HG)
AMX-014 "Doven Wolf" Neo Zeon Quasi Psycommu Mobile Suit Bandai 1:144
0189180 (HGUC 173) 2014 Нови части 14 October, 04:37
Marcin Dudek
добави нов фотоалбум.
добави нов фотоалбум.
26 15 September, 15:32
Marcin Dudek
A new build starte 🙂. It seems quite easy but one thing puzzles me - the tracks. They compose of 4 straight plastic parts and instruction says to bend them with hair dryer. It is first time I encountered this type of tracks. Anyone tried doing something like this?
A new build starte 🙂. It seems quite easy but one thing puzzles me - the tracks. They compose of 4 straight plastic parts and instruction says to bend them with hair dryer. It is first time I encountered this type of tracks. Anyone tried doing something like this?
15 September, 15:36
Snake Plissken
I have heard of this type of assembly but have never built one. However, I have lots of experience heating and softening styrene plastic. You can also try very hot or boiling water -- soak the tracks in boiling water, then fish them out of the water with long tweezers and bend them around the rear sprocket, idler and road wheels and hold until they cool. You may even get by using no heat, just slowly and carefully bend curves into the tracks.
I have heard of this type of assembly but have never built one. However, I have lots of experience heating and softening styrene plastic. You can also try very hot or boiling water -- soak the tracks in boiling water, then fish them out of the water with long tweezers and bend them around the rear sprocket, idler and road wheels and hold until they cool. You may even get by using no heat, just slowly and carefully bend curves into the tracks.
15 September, 20:46
Marcin Dudek
After some work done I need to say I am a little disappointed with this kit. Instruction includes some mistakes and it is not always easy to read how and where exactly a specific part should be located. More over I expected more from new molds (parts require a lot of work to remove additional plastic).
After some work done I need to say I am a little disappointed with this kit. Instruction includes some mistakes and it is not always easy to read how and where exactly a specific part should be located. More over I expected more from new molds (parts require a lot of work to remove additional plastic).
22 September, 13:17
Snake Plissken
Hi Marcin. My advice is to *expect mistakes* and do your research accordingly. It may or may not be fun to research the T-55 but most of the photos or line drawings you can find online are free, it just takes some time.
Hi Marcin. My advice is to *expect mistakes* and do your research accordingly. It may or may not be fun to research the T-55 but most of the photos or line drawings you can find online are free, it just takes some time.
25 September, 04:46
Snake Plissken
Good job adding the injector lines on the engine. I overlooked it the first time. 👍
Good job adding the injector lines on the engine. I overlooked it the first time. 👍
1 October, 05:53
Marcin Dudek
Thanks Snake 🙂. I was considering adding some more parts to the engine but they wouldn't be visible after assembly so I left it as it is. Thanks one again for the track bending tips, they were very helpfull.
Thanks Snake 🙂. I was considering adding some more parts to the engine but they wouldn't be visible after assembly so I left it as it is. Thanks one again for the track bending tips, they were very helpfull.
1 October, 15:48
Marcin Dudek
Some job with wearhering done. Still, I forgot to apply the decals first 🤦
Some job with wearhering done. Still, I forgot to apply the decals first 🤦
7 October, 05:41
Mark Sherwood
добави нов фотоалбум.
добави нов фотоалбум.
5 13 October, 13:25
Lebloge
we are in the presence of a man of taste… Leffe blonde… triple Westmalle « que du bon »😄
we are in the presence of a man of taste… Leffe blonde… triple Westmalle « que du bon »😄
13 October, 15:05
Mark Sherwood
Zybnek, Ben M 👍 it's cosy, stick a cd or record on and zone out modelling. Martin probably 🤣 Lebloge 👍 I have a few bottles of Duvel and La Chouffe too. Here's to escaping Thee Wife and the DIY It's either T'Club or the Box Room. 🤣🤘🥸🤟🤣
Zybnek, Ben M 👍 it's cosy, stick a cd or record on and zone out modelling. Martin probably 🤣 Lebloge 👍 I have a few bottles of Duvel and La Chouffe too. Here's to escaping Thee Wife and the DIY It's either T'Club or the Box Room. 🤣🤘🥸🤟🤣
13 October, 16:35
Mark Sherwood
Lebloge, Tetley's Imperial and you're right Beer or Modelling not both at the same time 😳🤣 Nicolas I agree. It's terrible that he succumbed to Alzheimer's. No more Discworld adventures.
Lebloge, Tetley's Imperial and you're right Beer or Modelling not both at the same time 😳🤣 Nicolas I agree. It's terrible that he succumbed to Alzheimer's. No more Discworld adventures.
13 October, 17:19
Rui S
And a big Windows and WC near by 😄 😄 😄 but I don't see a Bench, where do you build them?
And I disagree. Alcohol and model making are perfectly compatible, even your hands feel more firm, and steady 😄 😄 and if you mess things up you can blaim the licor and not your clumsiness or lack of tallent. I've a small fridge in my cave, só i know it hehe
And a big Windows and WC near by 😄 😄 😄 but I don't see a Bench, where do you build them?
And I disagree. Alcohol and model making are perfectly compatible, even your hands feel more firm, and steady 😄 😄 and if you mess things up you can blaim the licor and not your clumsiness or lack of tallent. I've a small fridge in my cave, só i know it hehe
13 October, 23:16
Mark Sherwood
Hi Rui, your cave just gets better, beer too 🍺🍺🍺🍺👍. I build to the left of the air brushes, it's small, but then I'm a short arse anyway 🤣 I intend to shelve the existing picture rails and the back wall which at the moment is piled up with tools,paint,nails, ladders and screws (Thee Wife, has got me painting the landing and the drop) I'll move the building over to the back wall as I will have natural light coming in. Come to think of it a fridge and Beer is not a bad Idea! 🤣👍🍺🤘🥸🤟🤣 Happy modelling mate.
Hi Rui, your cave just gets better, beer too 🍺🍺🍺🍺👍. I build to the left of the air brushes, it's small, but then I'm a short arse anyway 🤣 I intend to shelve the existing picture rails and the back wall which at the moment is piled up with tools,paint,nails, ladders and screws (Thee Wife, has got me painting the landing and the drop) I'll move the building over to the back wall as I will have natural light coming in. Come to think of it a fridge and Beer is not a bad Idea! 🤣👍🍺🤘🥸🤟🤣 Happy modelling mate.
14 October, 04:36
Loginthesand
търси този кит
търси този кит
HGUC Gundam Unicorn
NZ-666 Kshatriya Neo Zeon Prototype Mobile Suit for New Type Bandai 1:144
0160542 (099) 2009 Нова матрица 14 October, 04:36
Loginthesand
търси този кит
търси този кит
HGUC Gundam Unicorn
NZ-666 Kshatriya Neo Zeon Prototype Mobile Suit for New Type Bandai Spirits 1:144
5058263 (099) 2019 Нова кутия 14 October, 04:36
/bg/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=bg
35
35
/bg/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo