Prague Spring T-55
Коментари
9 9 September 2017, 00:58
![](/profiles/img/12266-226-s.jpg)
Great build, nice little improvements! Would be cool if you commented what and why you did in your building steps. Now give it a good wash!
30 September 2017, 09:54
![](/profiles/img/33919-895-s.jpg)
Thank you Alexander. I'll see if I can go back and comment on my mods to the kit...
and washes are coming.
5 October 2017, 03:26
![](/profiles/img/33919-895-s.jpg)
Thanks again Bob. I do enjoy building the Soviet "boogeyman" subjects.
15 July 2020, 02:16
![](/profiles/img/33919-895-s.jpg)
Thanks Joshua. I used mainly brass and copper wire for the fuel tank plumbing, along with a small section of aluminum rod for the thicker area between the two rear fuel tanks.
18 December 2020, 15:47
![](/profiles/img/33919-895-s.jpg)
I think that it's K&B products. I want to say that the brass is .010" size, but it may be .020". The aluminum rod is a bit bigger gauge size. I buy the stuff at whatever shops carry it. Train hobby shops, RC shops, Hobby Lobby, and the old school neighborhood hardware store (not Home Depot or Lowe's).
The copper wire I strip and salvage from electronics and appliances that go kaput and are being tossed into the garbage.
18 December 2020, 18:09