"Dornier Classics" Project. Part II: The X
Title
The first dry-fit
The first dry-fit
The first dry-fit
The kit has a long story, so the molds are not very fresh. Therefore, some panellines needed special attention with the dymo and the scriber
Size comparison - 1\72 Wal and 1\144 X!
Size comparison - 1\72 Wal and 1\144 X!
Size comparison - 1\72 Wal and 1\144 X!
Assembled main structural parts
Assembled main structural parts
Assembled main structural parts
Assembled main structural parts
Assembled main structural parts
Top of hull is still not glued to the hull sides - it will make the work easier for now)
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Completed the main body, restored the corrugated surfaces, masked!
Engines are still in the work
Engines are still in the work
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
Engine sub-assembly finished.
All painted up!
All painted up!
All painted up!
All painted up!
All painted up!
All painted up!
All painted up!
Коментари
6 9 July 2018, 07:51
Dmitriy Andreeshchev
Update! Assembled main structural parts. This model is way easier then the Wal from Amodel 🙂
Update! Assembled main structural parts. This model is way easier then the Wal from Amodel 🙂
22 July 2018, 15:56
Dmitriy Andreeshchev
An update: Completed the main body, restored the corrugated surfaces, masked! Started to work this engines - those require a lot of refinement!
An update: Completed the main body, restored the corrugated surfaces, masked! Started to work this engines - those require a lot of refinement!
7 August 2018, 17:25
Dmitriy Andreeshchev
Update: finished the engine subassembly! Very difficult part of the build, lots of cleanup and filler, and strut attachment between engines is extremely fiddly!
Update: finished the engine subassembly! Very difficult part of the build, lots of cleanup and filler, and strut attachment between engines is extremely fiddly!
11 August 2018, 18:03
Bernhard Schrock
Very remarcable result especially the NM finish! The numbers on upper side of wings: airbrushed or decals?
Very remarcable result especially the NM finish! The numbers on upper side of wings: airbrushed or decals?
14 August 2018, 04:02
Dmitriy Andreeshchev
Bernhard, I used decals from the kit. Even considering tha fact, that they were a bit old and with some cracks in them, they worked good. And thank you! My gratitude also goes to Alec K, Julian, bobinspokaloo and Spanjaard!
Bernhard, I used decals from the kit. Even considering tha fact, that they were a bit old and with some cracks in them, they worked good. And thank you! My gratitude also goes to Alec K, Julian, bobinspokaloo and Spanjaard!
14 August 2018, 08:34