AMT Freightliner FLA
Коментари
2 30 June 2019, 21:23
Bill NewcomerHi, Nice truck. I am about to start building two of these. Any fitment issues you could share with me?
16 September 2019, 05:41
Brandon HThanks Bill! I did notice when mounting the cab to the chassis that the air intake and shift linkage came in a bit too high, so you'll probably want to wait to cement those in place until you can dry fit the cab. The floorpan into the cab exterior was also a pretty tight fit.
16 September 2019, 23:50
Bill NewcomerThanks Brandon. I will watch for that. I am contemplating using the V8 and longer chassis from a Ford Straight truck. (I just can't leave well enough alone)
17 September 2019, 02:00
Chris GreathouseBrandon, What did you do about that nasty half seam on the cabin shell parts? I couldn't think of anything with mine without ruining the textured rivets, so I did nothing...
17 September 2019, 02:11
Brandon HChris, I didn't end up having to do much with the seem where the cab halves join together - it is still somewhat visible on mine if you look closely. It can be helped with some careful deflashing; making sure the halves fit flat against each other before cementing. It may also come out worse on some kits than others - who knows how old the tool for the cab is... anyway despite that, I think yours turned out nice!
18 September 2019, 14:57
Chris GreathouseThanks! The first kit of mine that didn't come with a color scheme, I freaked out a little then just had fun!
18 September 2019, 18:51
