Polikarpov I-15
![Album image #1 Album image #1](/albums/img/2/8/8/851288-58861-95-720.jpg)
The gunsight and MG blast tubes are Albion Alloys .7mm brass tubing.
![Album image #2 Album image #2](/albums/img/2/8/9/851289-58861-32-720.jpg)
The I-15 kit was the worst of the three I built together. The main wing struts and wheel struts do not have locating pins. There were also a lot of plastic blobs on the surface of the wing.
![Album image #3 Album image #3](/albums/img/2/9/0/851290-58861-96-720.jpg)
The decals went down without any issues. The paint scheme is AE-9 light gray metal with aluminum doped fabric. I used AK Interactive RC308 and RC020 paints.
![Album image #4 Album image #4](/albums/img/2/9/1/851291-58861-75-720.jpg)
The engine exhaust stubs are Albion Alloys MBT09 tubing.
![Album image #5 Album image #5](/albums/img/2/9/2/851292-58861-94-720.jpg)
The rigging is Infini Aero rigging. I tried to pull the rigging through the fuselage when possible to get it tight, but I had to drill through the bottom wing for the rear rigging.
![Album image #6 Album image #6](/albums/img/2/9/3/851293-58861-33-720.jpg)
The I-15 in 1/72 scale is small. I did not spend much time on the cockpit as you don't see much of it.
![Album image #7 Album image #7](/albums/img/2/9/4/851294-58861-76-720.jpg)
Коментари
3 27 September 2020, 20:29
![](/profiles/img/58017-515-s.jpg)
very impressive at this scale a lot of detail giving a good view of the engine
25 October 2023, 08:09