Стена

Mr James
Nice work. I'm half way through doing my own but lost interest with all the decals. I like your weathering

Tiny Hangar
Thank you for comment the kit has plenty in terms of decals good luck 😊👋

Tiny Hangar
After a long time, the ICM spitfire kit is done

The kit was too challenging for me but thanks to many defective parts improved myself

I used too much putty, sand, and blade

First of all, the main problem is the engine, which cannot fit with fusalage. There was a huge gap between the fusalage parts because the engine wall was too wide to fit, so I canceled the engine and glued fusalage parts without the engine.

Cockpit bottom piece overflows from the fusalage and hinders the wing fitting thus, I cut and sanded the overflowed piece, even if it was enough to glue it. Still, there was a gap, so I filled all the gaps with putty.

Also, some parts are not matching each other with panel lines. So we decided to send photos and problems to ICM via email, and after a few emails, ICM accepted the problems and said that we would send new spures.

All the problems announced me, moreover after the engine and fuselage problems I wanted to quit but I didn't give up and decided to complete and try the all techniques that ı wanted to try on the kit

So Spitfire seems to be so tired now 🙂

Andy Dallibar
Very nice indeed.

Tiny Hangar
Thank you 👋

"Sparky"
Just a great job in modeling! Detail is fantastic.

Tiny Hangar
Thank you for well comment
It was cheap but good kit I enjoyed 😊

Doubtingmango
Excellent work! That's shows what can be done with an aged, simple, fun kit

Tiny Hangar
Thank you 👋

Tiny Hangar
After a long time, the ICM spitfire kit is done

The kit was too challenging for me but thanks to many defective parts improved myself

I used too much putty, sand, and blade

First of all, the main problem is the engine, which cannot fit with fusalage. There was a huge gap between the fusalage parts because the engine wall was too wide to fit, so I canceled the engine and glued fusalage parts without the engine.

Cockpit bottom piece overflows from the fusalage and hinders the wing fitting thus, I cut and sanded the overflowed piece, even if it was enough to glue it. Still, there was a gap, so I filled all the gaps with putty.

Also, some parts are not matching each other with panel lines. So we decided to send photos and problems to ICM via email, and after a few emails, ICM accepted the problems and said that we would send new spures.

All the problems announced me, moreover after the engine and fuselage problems I wanted to quit but I didn't give up and decided to complete and try the all techniques that ı wanted to try on the kit

So Spitfire seems to be so tired now 🙂

Gerald
Hello Welcome here 😉