M777 Howithzer
Toto album neobsahuje žádné obrázky.
Komentáře
Album info
Another one done, Luis Vargas 1/35 3D printed M777 howitzer, complemented by a US Artillery set also 3D printed by Holden8702.
The kit comes in 30-40 parts on “sprues” consisting of 3D supports. Fewer parts than a plastic kit, since each part contains lots of intricate detail in itself. No sanding of mold lines or filling of ejection pin marks was a bonus.
.
Assembly was straightforward, with only three minor issues: a) a support arm under the gun was too short for the 45 deg. angle and had to be lengthened; b) the left electronics screen is too low to allow fitting one of the adjustment wheels and needs to be repositioned; c) part of the barrel assembly (which isn’t visible) is a bit too short.
.
Instructions are different, consisting of 3D drawings with parts highlighted in color to show their locations. A number of pages are dedicated to placement of hydraulic lines, which I only partially added here.
.
Overall a superb kit, even if having to use CA glue exclusively can be unforgiving. I used five minute epoxy on joints that required more strength. There are few print layer lines visible which disappear once primed and painted.
.
The figures were well done and each came in a single piece of clear resin. I’m happy with the results and had fun putting things together.