MyAlbum

Picture of the subject I will be modeling 

I'll be doing the box cover version 

 

 

 

 

Started work on the CMK interior set. First step is to cut off the section of the fuselage behind the seat to show off the fuel tank behind the seat, which you can see in the upper fuselage half in the picture. 

Cockpit tub from the CMK interior set. Was a bit too wide for the fuselage halves, so had to sand it back a bit so the fuselage could close properly. 

Now fuselage halves close nicely, and the fuel tank is visible. 

Cutting open the fuselage panels for the CMK and Aires aftermarket (top halves). Bottom halves will be used in a second diorama with limited aftermarket. 

Wings cut to add the wing fuel tank tubs (CMK exterior set) and remove the flaps. 

Wings cut to add the undercarriage tubs (CMK undercarriage set) and ammo magazine (CMK armament set). 

CMK cockpit set - really nice, but takes some adjusting to get the fuselage halves to fit. 

Fitting all the CMK sets in the wings is a bit tricky, and as noted in the CMK undercarriage set, you need to file back the sets to make it all fit. Here you can see how much the undercarriage tubs need to be filed back to fit the wing fuel tanks. In the fuselage picture above, you can see the opening I needed to make in the fuselage to fit the corner of the ammo magazine. 

CMK cockpit set inserted. 

Right side fuselage with MG 151 open panel (Aires) and FuG 7 radio (CMK armament set). 

Left side fuselage with luggage compartment open (CMK armament set). 

Fuselage closed compared with second Hs 129 built for a separate diorama.