Eduard Fokker Dr.I stripdown
engine resin base
engine, freeing the tubes
engine, freeing the tubes
busy soldering
PE-base for mg's
one MG finished
soldering the engine mount
basepart upper wing
folded and ready for soldering
soldered wing, still need to clean-up
soldered wing, still need to clean-up
soldered wing, still need to clean-up
baseparts
base midwing
base midwing
testfit
With frontparts in place
With frontparts in place
bottomplate treated with woodpaint from vallejo and oil-paint for veneer look, a tad too dark in my opinion
sideplates treated with decals from uschi, paint on the sides needs to be cleaned
centre spar with same treatment as with the bottomplate, but instead with pushing the brush up and down, you streak the brush lenghtwise
wheels need to be repainted/cleaned up
different stages of painting the wings
some detail
better picture of the engine
The hull, almost complete
and it's mega-size, still regretting the airco dh-1 1:144 as stripdown-model
struts
Komentáře
17 October 2024, 04:44 -