Wingnut Wings Albatros D.Va (OAW)
Cooling jackets annealed and rolled.
Wiring harness. I used a seven strand wire. I pulled one strand out, and left a tiny bit of insulation to hold them together. Drilled a 0.010" (.25mm) hole in the end of the plastic. I pulled one strand out slightly to engage in the hole, then applied CA.
Ready to attach wires to magneto.
Komentáře
22 April 2017, 15:41
Bill Scarbrough
Thanks, Moritz! The detail on these kits is amazing, I hope I can do it justice.
Thanks, Moritz! The detail on these kits is amazing, I hope I can do it justice.
22 April 2017, 23:21
Gordon Sørensen
The detail of these Wingnut kits is incredible. Your interior looks great, Bill!
The detail of these Wingnut kits is incredible. Your interior looks great, Bill!
28 April 2017, 12:53
Bill Scarbrough
I used the markings to show me which parts were airbrushed different base coat colors, Holger.
I used the markings to show me which parts were airbrushed different base coat colors, Holger.
28 April 2017, 13:38
Holger Kranich
Ha, i had something in mind like that. Nice idea!🙂 I copy that when my Albatros BII comes on the bench. These WNW Kits are stunning! Whats your rigging stuff? EZ Line?
Ha, i had something in mind like that. Nice idea!🙂 I copy that when my Albatros BII comes on the bench. These WNW Kits are stunning! Whats your rigging stuff? EZ Line?
28 April 2017, 13:42
Album info
Built OOB