03 - Assembling the Sd.Kfz.234/2 PUMA
1
March 27, 2020starting making the welding lines2
March 27, 2020basic chassis assembly ready3
March 27, 2020we will open the solder of the upper front plate4
March 27, 2020plate separated from the rest of the vehicle5
March 27, 2020opening welding lines!6
March 27, 2020mantlet casting mark7
March 27, 2020mantlet casting mark8
March 27, 2020opening the seam slit in the tower front panel9
March 27, 2020opening the other weld slits and dividing the front plates of the vehicle10
March 27, 2020starting to fill the pits and making the welding marks with sprue stretched, here the front of the vehicle11
March 27, 2020starting to fill the pits and making the weld marks with sprue stretched12
March 27, 2020starting to fill the pits and making the weld marks with sprue stretched, here the bottom of the front13
March 27, 2020starting to fill the pits and making the weld marks with sprue stretched, here the top of the rear14
March 27, 2020starting to fill the pits and making the weld marks with sprue stretched, here the bottom of the rear of the chassis15
March 27, 2020more welding marks16
March 27, 2020putting the more apparent screws17
March 27, 2020Dry-fit everything to see how it's going! I also made the groove dividing the fender plates in two parts18
March 27, 2020putting the wheels in place and following the Dry-fit19
March 27, 2020for a change, the old Italeri fine finishes are mostly weak, some very few that are saved, which is not the case in this kit here!20
March 27, 2020tools and extinguishers here came from spare parts thanks to Dragon, the shovels kept the original ones because they were better than the ones I had in stock! I also put some rivets on the divider line of the fenders21
March 27, 2020making the brake lines with sprue stretched and joint protectors in scratch because those in the kit were very awful22
March 27, 2020making the brake lines with sprue stretched and joint protectors in scratch because those in the kit were very coarse23
March 27, 2020joint protectors in scratch because those in the kit were very coarse24
March 27, 2020Headlights came from the Tiger I Academy and extinguishers and tools from Dragon's parts stock25
March 27, 2020I had thought about making the side chest in scratch, but I decided to keep the gallons in the rear as Italeri did26
March 27, 202027
March 27, 202028
March 27, 2020references for 20L Gallon holders29
March 28, 2020Gallon holders made on the nail with plasticard and lots of patience!30
March 27, 2020and it really demanded a LOT of patience, 0.10mm plasticard sheet, to look at it already broke, I made the necessary amount for the whole car and just ended up using one! hahahahaha31
March 27, 2020taking shape! bumper screws made from scratch too!32
March 27, 2020casted Iron33
March 27, 2020small Dry-fit of everything to see how it is getting! and here you can see the antenna support made in scratch!34
March 27, 202035
March 27, 202036
March 27, 2020here you can see the antenna support made in scratch!37
March 28, 2020Dragon tools rear side38
March 27, 2020
Komentáře
27 March 2020, 08:02
Project info
137 obrázky