MAKING EXHAUST PIPES
![Album image #1 Album image #1](/albums/img/7/8/9/784789-30596-21-pristine.jpg)
These are the kit exhaust pipes. Really poor job from KP.
![Album image #2 Album image #2](/albums/img/7/8/2/784782-30596-59-pristine.jpg)
Take some .040" (1mm) styrene rod and drill a .025" (.6mm) hole in the end.
![Album image #3 Album image #3](/albums/img/7/8/3/784783-30596-47-pristine.jpg)
Put some flat black in the hole.
![Album image #4 Album image #4](/albums/img/7/8/7/784787-30596-30-pristine.jpg)
Paint the pipe steel colour or whatever you normally do.
![Album image #5 Album image #5](/albums/img/7/8/4/784784-30596-10-pristine.jpg)
The kit part would normally glue on here. Ugh!
![Album image #6 Album image #6](/albums/img/7/8/5/784785-30596-73-pristine.jpg)
Drill a hole to fit the pipe on an angle as shown.
![Album image #7 Album image #7](/albums/img/7/8/6/784786-30596-19-pristine.jpg)
Cut the rod to the correct length and glue it in.
![Album image #8 Album image #8](/albums/img/7/8/8/784788-30596-29-pristine.jpg)
Much better looking than the kit parts.
Komentáře
3 June 2020, 14:37
Album info
Replace ugly kit parts with something more realistic.