modelářská databáze | správa kitníku
UrsusMagnus
Björn Svedberg (UrsusMagnus)
SE

Birdcage Progress

Komentáře

39 23 August 2020, 16:58
Björn Svedberg
I've started the build of the Tamiya Birdcage Corsair. The plan is to build it with folded wings along with the pilots and ground crew kit.
23 August 2020, 17:00
Daniel Klink
Hi Björn... nice to read you again following of course.
Hope you are doing fine!
23 August 2020, 17:10
James C
Off to a great start. Following 👍
23 August 2020, 18:33
Björn Svedberg
Thank you friends! 🙂
I'm fine thank you, Daniel! Hope you are doing fine, too!
24 August 2020, 15:18
Erik Leijdens
Great start Björn! Looks good, as always!
24 August 2020, 15:41
Roland Sachsenhofer
Wonderful work on Cockpit and engine! I am looking forward seeing your skills at work!
24 August 2020, 17:26
Björn Svedberg
Thank you Erik and Roland! 🙂
A little bit of an update. I have finished the riveting and the masking of the cockpit and I have also done the pre-shading and marbling before the paint.
I decided to go with a paint set from Hataka this time, so the next update will have to wait until it arrives.
12 September 2020, 17:43
Björn Svedberg
Another update. The camo is finished. Although I'm happy with the end result, the Hataka paints is going to take a while to get used to. They are not like the gunze/mr. color and Tamya that I usually use.
Next up is decals. 🙂
15 September 2020, 14:35
James C
The camouflage and colours look amazing 👍
Do you mind me asking what was happening with the Hataka paints and were you using the acrylic set?
15 September 2020, 19:43
Björn Svedberg
Thanks James!
Yes, it was the acrylic set. I had a couple of things happen. I used the Hataka acrylic thinner to thin the paint for the airbrush and it had quite alot of soapy stuff in it creating bubbles in the paint mix in the cup of the airbrush, which resulted in a very uneven paint spray out of the airbrush. I guess that could just be me getting the mix wrong, but I will probably use tamiya X-20A as a thinner the next time.
The second thing is that I sometimes use Mr.Color Leveling thinner to thin acrylic paints and that did not work at all with these paints. That mix turned into a stringy gunk that clogged up the airbrush.
But I'm sure they will work just fine when I have worked with them a bit more and learned how to use them properly. As I said, I am happy with the end result. 🙂
15 September 2020, 22:40
James C
Thanks for the info... I've got a couple Hataka acrylic sets that I've not tried yet.
16 September 2020, 01:56
Guillaume Blanchet
Looking great so far!
16 September 2020, 02:11
Clifford Keesler
Agree with everyone, looking great.
16 September 2020, 02:26
Slavo Hazucha
I´ll pop in here too - progress looks great so far - I really like your approach to surface wear 👍
16 September 2020, 11:58
Björn Svedberg
Thank you Guillaume, Clifford and Slavo.
Decals are now on so the next step is weathering and some detail painting to finish it up. 🙂
17 September 2020, 11:14
Björn Svedberg
I have done the first stage of weathering with oil washes and a matt layer on top of that. After assembly, I will do some additional weathering and detail painting. I will keep it as clean as I can for this one.
19 September 2020, 13:34
Laurent VILLANUEVA HELLER ForEver
fabulous
19 September 2020, 13:42
Chris Church
Detail work on the cockpit and engine looks fantastic.
19 September 2020, 13:53
Roland Sachsenhofer
Precisely done work, looks just wonderful!
19 September 2020, 13:58
Clifford Keesler
Looking awesome sir.
19 September 2020, 21:01
Scott Dutton
Beautiful work, I enjoy seeing how people paint at what level of subassemblies Vs masking. Your airbrush control is amazing, the preshading is a work of art by itself
19 September 2020, 22:29
Björn Svedberg
Thank you Laurent, Chris, Roland, Clifford and Scott! 🙂
The Corsair is now finished, but I still have the moto-tug and the pilots and crew to finish before I close this project.
20 September 2020, 13:09
bughunter
What a clean work and paint job 👍 all those little lovely sub assemblies ... Wonderful!
20 September 2020, 17:40
Christian Kohl
Very nice job, Björn. Very lovely done!😉
20 September 2020, 17:41
Hanno Kleinecke
What a paintjob ! You perfectly captured the sun beaten, chalked out look of these hard used airplanes !
22 September 2020, 06:18
Micky
Excelent paint job!
22 September 2020, 13:23
Björn Svedberg
Thank you very much for all the feedback, mates! 🙂
I've added the Eduard Essex class carrier deck to the project, so I will have to find some good reference for the painting. It looks like it will be a nice addition with all the weathered wood and steel.😉
22 September 2020, 14:57
Björn Svedberg
Another update. I have started working on the figures and finished the little moto-tug. Next will be some figure painting. 🙂
6 October 2020, 15:06
Micky
Watching with interest Björn!!
7 October 2020, 13:13
Björn Svedberg
You are very welcome, Micky! 🙂
Another update. I have finished the drop tank and also worked on the carrier deck. I will probably do some more weathering of the deck in the future. Tyre marks oil spill etc, but as for now I consider it finished. Now I only have the figure painting left to do.
12 October 2020, 14:26
Slavo Hazucha
The deck looks absolutely fabulous, great contrast between metal & wood and top mild weathering effects 👍
12 October 2020, 15:30
bughunter
Very nice detail painting on the deck! I like it 👍
12 October 2020, 15:34
Clifford Keesler
That is looking very very nice.
12 October 2020, 22:09
Christian Kohl
Very nice work Björn. It's really fun to watch what you're doing.
13 October 2020, 03:52
Björn Svedberg
Thank you Slavo, bughunter, Clifford and Christian!
I have finished the figure painting and taken a few finishing photos. This project was alot of fun to do! 🙂
On to the next one!😉
17 October 2020, 18:14
James C
Outstanding build Björn. The Corsair looks amazing, and the crew figures are the icing on the cake. Phenomenal paintwork! 👍👍👍
17 October 2020, 18:18
Clifford Keesler
Beautiful work on the figures, and Corsair. Well done.
17 October 2020, 23:21
Lochsa River
Really Nice....congratulations
18 October 2020, 00:55
Roland Sachsenhofer
Impressive piece of modeling art, wonderful work and outcome! Congratulations Björn!
18 October 2020, 04:22
Germen V
very nice, congrats
18 October 2020, 07:41
Alex Rodionov
Great work. No words.
18 October 2020, 07:44
Neuling
Very beautiful diorama in every aspect. A feast for the eyes indeed.👍👍👍
18 October 2020, 10:19
Daniel Klink
Fully agree with Neuling..
Especially the Figures looking awesome 👍
But they are all missing the eyes..
18 October 2020, 11:23
Björn Svedberg
Thank you very much, mates! You all inspire me to become a better modeler! And the feedback is very much appreciated. 🙂
@Daniel, Thank you, and yes, painting eyes in this scale is something I haven't mastered yet. I promise you that they would look far more creepy if I had tried that.😉
18 October 2020, 15:00
bughunter
The group of pilots is absolutely impressive, very lifelike! Not just the painting, but also the postures and last but not least the photography! Awesome!
18 October 2020, 16:15
berni
Hello Björn, a very good result for someone who started modeling in 2017 👍
18 October 2020, 17:25
Björn Svedberg
Thank you bughunter and berni! 🙂
22 October 2020, 04:54
Mark
Outstanding build and figures 👍👍👍
20 December 2021, 21:04

Album info

Build pictures of my build of the Tamiya 1:48-scale F4U-1 Birdcage Corsair.

61 obrázky
1:48
Dokončeno
1:48 Chance Vought F4U-1/2 Bird Cage Corsair (Tamiya 61046)1:48 WWII U.S. Navy Pilots w/Moto-Tug (Tamiya 61107)1:48 F4U-1D Corsair (Eduard FE215)3+
Vought F4U-1 Corsair
US US Navy (1794-now)
VF-17 Jolly Rogers 17-F-13
World War 2 - USS Bunker Hill
FS15050 FS35193 FS17925
 

Všechna alba

Zobrazit všechna alba »