Harrier AV-8S Matador 1/48 AMMO
Lets go!
First parts, some Mr.Surfacer to fill extrusion marks
Mr.Surfacer on some wrong panel lines from the mold
Some details to the seat using thin aluminum foil and transparent film. Thanks ScaleATon for the idea 😛
White!
Cockpit colors
Instrument panel with some Airscale dials
Seat painted
Cockpit painted
Wheel wells painted and weathered
Seat weathered
These parts make impossible to fit later the exhaust, so I will not use them
These parts make impossible to fit later the exhaust, so I will not use them
Closed!
Closed!
Wings in place, some CA to fill gaps
Cleaning and gluing!
Had to fill the thin line between the tires and the rim...
First round of putty!
First round of putty!
Second round!
Second round!
Almost everything cleaned and ready to primer 🙂
Rescribing lost and incorrect panel lines...
Rescribing lost and incorrect panel lines...
Some detailing in the 30mm cannons pods with a needle
Some detailing in the 30mm cannons pods with evergreen
Sanding and more sanding until its ready. Hard steps in the rear central part of the wings... But finally ready for painting!!
Enhancing a little bit the cockpit visor...
Enhancing a little bit the cockpit visor...
In place!
Mr Surfacer 1500 black primer to prepare the marbling
Marbling done!
Marbling done!
Marbling done!
Lower side color done! Light coats of base color to let the marbling do its effect
Lower side color done! Light coats of base color to let the marbling do its effect
Lower side color done! Light coats of base color to let the marbling do its effect
Upper side color!
Upper side color!
Komentáře
20 21 November 2021, 02:27
Jorge Gallego-Madrid
Thanks everyone!!
I got the idea of the seat from this ScaleATon video: Youtube Video
Regarding the kit itself, I have to admit that I was expecting a better quality from Kinetic. The fitting is not very good, some parts have serious flaws that require some work, and the rivets and panel lines does not fit very well between the two parts of the fuselage. Besides, it seems like the moulds have been corrected at some point, and there are some "old" panel lines and rivets that have not been totally removed from the moulds.
Thanks everyone!!
I got the idea of the seat from this ScaleATon video: Youtube Video
Regarding the kit itself, I have to admit that I was expecting a better quality from Kinetic. The fitting is not very good, some parts have serious flaws that require some work, and the rivets and panel lines does not fit very well between the two parts of the fuselage. Besides, it seems like the moulds have been corrected at some point, and there are some "old" panel lines and rivets that have not been totally removed from the moulds.
16 December 2021, 09:53