Newsfeed
Juergen Klinglhuber
hat ein neues Fotoalbum hinzugefügt.
hat ein neues Fotoalbum hinzugefügt.
34 Bilder
Junkers 86 K7 - Austrian markings '37Neu: 11 August, 15:07 1:72
Projekt: Junkers 86 - Austrian markings '37
29 31 May, 15:38
Juergen Klinglhuber
Started this one.
The Ju 86 which were seen in 2 different Austrian markings, but at the end was never part of the Airforce. Here the overall silver Ju86 #311 at the airshow in Vienna-Aspern in early 1937.
Started this one.
The Ju 86 which were seen in 2 different Austrian markings, but at the end was never part of the Airforce. Here the overall silver Ju86 #311 at the airshow in Vienna-Aspern in early 1937.
2 June, 11:10
Juergen Klinglhuber
The mention aircraft was sent to the Airshow in Aspern as a "demonstrator" in austrian marking. Austria was interessed in buying 18 Ju86K-7. Due to several reasons Junkers was not prepared for that airshow and on short note removed the markings of an 86K-2 that was already prepared to be sold to Sweden. They put on austrian markings, a service number #311 and flew it over to Austria for just this one day. Flight captain Behrendt did a good job and the aerobatic air-display was a great success. So far so good. Why I am telling this? 86-K2 is a differend engine and cowling. The box is a 86E1/2. Aftermarket conversion products are out there (Kora) .....I had difficulties to locate/buy some.
Therefore: it is Scratchbuilding time again !!! 😎
The mention aircraft was sent to the Airshow in Aspern as a "demonstrator" in austrian marking. Austria was interessed in buying 18 Ju86K-7. Due to several reasons Junkers was not prepared for that airshow and on short note removed the markings of an 86K-2 that was already prepared to be sold to Sweden. They put on austrian markings, a service number #311 and flew it over to Austria for just this one day. Flight captain Behrendt did a good job and the aerobatic air-display was a great success. So far so good. Why I am telling this? 86-K2 is a differend engine and cowling. The box is a 86E1/2. Aftermarket conversion products are out there (Kora) .....I had difficulties to locate/buy some.
Therefore: it is Scratchbuilding time again !!! 😎
5 June, 18:16
Juergen Klinglhuber
thx Alec &Lukasz for you very kind support 👍 - appreciated.
But the first cuts are already done - no way back now 😉
(and I have to odmit: usually I like it to test my skills by a DIY task every now and then)
thx Alec &Lukasz for you very kind support 👍 - appreciated.
But the first cuts are already done - no way back now 😉
(and I have to odmit: usually I like it to test my skills by a DIY task every now and then)
5 June, 18:51
Stefan Fraundorfer
Ah, a new and very interesting project. Of course I will follow that. Have fun with the Ju 86 Jürgen.
Ah, a new and very interesting project. Of course I will follow that. Have fun with the Ju 86 Jürgen.
15 June, 07:23
Juergen Klinglhuber
I have finished the modification on the engine resp. cowling. Some new pic's up-loaded.
I have finished the modification on the engine resp. cowling. Some new pic's up-loaded.
23 June, 15:27
Roland Sachsenhofer
Very interesting and extremely promising! We talked about it in Ried, and now I'm delighted to see these ideas being realised in such an impressive way!
Very interesting and extremely promising! We talked about it in Ried, and now I'm delighted to see these ideas being realised in such an impressive way!
23 June, 15:30
TH SCALE MODELS (Thomas Haberl)
Nice progress Jürgen! I´m in to see how this beauty comes together 👍
Nice progress Jürgen! I´m in to see how this beauty comes together 👍
24 June, 14:07
Juergen Klinglhuber
Thank you mates for leaving your nice comments.Iam wWorking on the exhaust pipe currently. New picture up-date should be ready after this coming weekend.
Thank you mates for leaving your nice comments.Iam wWorking on the exhaust pipe currently. New picture up-date should be ready after this coming weekend.
3 July, 17:07
Juergen Klinglhuber
All mod's are completted now - after adding the windows of the cockpit I can move it to the paint hangar.
All mod's are completted now - after adding the windows of the cockpit I can move it to the paint hangar.
13 July, 20:27
Juergen Klinglhuber
Hey - thank you Roland for your feedback. That gives motivation of course 🙂
Hey - thank you Roland for your feedback. That gives motivation of course 🙂
14 July, 16:01
Roland Sachsenhofer
That's great, that's how it should be, because your construction progress here gives me inspiration 🙂
That's great, that's how it should be, because your construction progress here gives me inspiration 🙂
14 July, 17:20
Juergen Klinglhuber
Thank you Alec, Thomas & Cuajete. When I had finished I thought: "Grab, overdone. This bird was for sure not that worn as it went to the airshow more or less fresh from the manufacturer." But the more looked at it the more I was okay with the result. So your comments are welcome and soothe my concerns. 👍
Thank you Alec, Thomas & Cuajete. When I had finished I thought: "Grab, overdone. This bird was for sure not that worn as it went to the airshow more or less fresh from the manufacturer." But the more looked at it the more I was okay with the result. So your comments are welcome and soothe my concerns. 👍
9 August, 16:22
Nicolas
Don't worry Juergen, even on new airplanes there are sometimes clear visual differences in the sheet metal. For example, some manufacturers deburr the rivet holes with a grinding machine, the sheets are made of different alloys or are applied with different rolling directions, all of which have an influence on the appearance. I like it.
Don't worry Juergen, even on new airplanes there are sometimes clear visual differences in the sheet metal. For example, some manufacturers deburr the rivet holes with a grinding machine, the sheets are made of different alloys or are applied with different rolling directions, all of which have an influence on the appearance. I like it.
9 August, 19:16
Eric Duval
hat ein neues Fotoalbum hinzugefügt.
hat ein neues Fotoalbum hinzugefügt.
8 29 March, 21:20
Łukasz Gliński
No way these figures are 1/72, are you sure you picked the correct scale in the description? 😮
No way these figures are 1/72, are you sure you picked the correct scale in the description? 😮
27 May, 09:03
Krzysztof Szymkiewicz
hat ein neues Fotoalbum hinzugefügt.
hat ein neues Fotoalbum hinzugefügt.
13 10 August, 18:05
Pietro De Angelis
Great Humber, I have one in the stash too, when I get around to making it one day I hope it turns out half as good as yours!
Great Humber, I have one in the stash too, when I get around to making it one day I hope it turns out half as good as yours!
10 August, 19:08
Krzysztof Szymkiewicz
Thank you 😃 The model itself is very nice to build, the instructions are only sometimes unclear.
Thank you 😃 The model itself is very nice to build, the instructions are only sometimes unclear.
10 August, 19:31
Triathlete
besitzt diesen Artikel
besitzt diesen Artikel
McLaren Honda MP4/4 Marlb*** Shell
Tabu Design 1:20
TABU20015B 11 August, 14:57
Tim Webb
hat diesen Artikel bestellt
hat diesen Artikel bestellt
U.S.
Howitzer Motor Carriage M8 "Awaiting Orders" Set (w/3 figures) Tamiya 1:35
35312 2010 Neue Bauteile 11 August, 14:53
Doubtingmango
hat ein neues Fotoalbum hinzugefügt.
hat ein neues Fotoalbum hinzugefügt.
18 3 August, 19:52
Mark Sherwood
A nice looking model. Detailing, crew and rendered wear and tear. Spot on. 👍🥸🤟
A nice looking model. Detailing, crew and rendered wear and tear. Spot on. 👍🥸🤟
4 August, 04:34
Doubtingmango
My tracks snapped overnight after the washed! I replaced them with old Tamiya tracks and added a recognition flag on the back (added pics)
My tracks snapped overnight after the washed! I replaced them with old Tamiya tracks and added a recognition flag on the back (added pics)
6 August, 23:41
Davide Vitali
Very nice! Please, note that the Italian flag in the ww2 was different in that it had the Royal family's icon on the white stripe
Very nice! Please, note that the Italian flag in the ww2 was different in that it had the Royal family's icon on the white stripe
7 August, 09:07
Doubtingmango
You are correct Davide! I attempted the correct flag multiple times with a print out, but the ink kept running. I used acrylic paint to do a simple Italian tricolor. Maybe the crew had a few too many close calls with the stukas and made their own simple tricolor?
You are correct Davide! I attempted the correct flag multiple times with a print out, but the ink kept running. I used acrylic paint to do a simple Italian tricolor. Maybe the crew had a few too many close calls with the stukas and made their own simple tricolor?
7 August, 09:46
Marc-Antoine Manini
will diesen Artikel
will diesen Artikel
60’~70's Southern Vietnamese & Japanese SS50E Motorbike Set Academy
Gecko Models 1:35
35GM0127 2024 Neue Bausatzform Mehrfachthemen (2)11 August, 14:49
Triathlete
besitzt diesen Artikel
besitzt diesen Artikel
Cadillac DPi-V.R "KONICA MINOLTA" Winner Daytona´19 #10 Taylor/Kobayashi/van der Zande/Alonso
Le Mans Decals 1:24
2020 11 August, 14:45
/de/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=de
35
35
/de/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo