Bugatti Type 35B Part 5 Body Panels Steps 29-34
![Album image #1 Album image #1](/albums/img/8/1/5/1638815-66862-69-720.jpg)
Dash with all the controls added before body was installed
![Album image #2 Album image #2](/albums/img/8/1/6/1638816-66862-55-720.jpg)
Right front panel alignments, you can see here that the French blue I used for the frame is darker than the molded color.
![Album image #3 Album image #3](/albums/img/8/1/7/1638817-66862-87-720.jpg)
Right side panel align ment and gasket for shift knob
![Album image #4 Album image #4](/albums/img/8/1/8/1638818-66862-22-720.jpg)
Rear lelt alignment and exhaust bracket
![Album image #5 Album image #5](/albums/img/8/1/9/1638819-66862-56-720.jpg)
Front left alighment of panles
![Album image #6 Album image #6](/albums/img/8/2/0/1638820-66862-69-720.jpg)
Left side body work overall
Kommentare
3 12 January, 22:15
Album info
I started attaching the body panels to the completed chassis. I decided to keep the molded color for the panels, so I polished them using Nexus 3 step polisher and a polish attachment to my Dremel. I wanted to make sure the panels weren't marred by excess glue so I test fitted each panel first and then a bead of Faller Expert glue to the inside seam of the panel. I then touched any seams up with Tamiya extra thin cement. I had to clamp the rear body part during this process to make sure the seams were tight to the lower body assembly, I also installed all the dashboard switches and knobs before I put the body on. I was amazed at the excellant fit and alignment for all the panels and access points for future assembly