RHAF WC54 Ambulance
Step one: Engine
A piece that supports the engine was missing from the chassis. Out of styrene fit, I made a replacement
Co-driver's seat needed adjastment
Tow hook was missing as well. I scratched one
The fuel nozzle is different from the real thing, so some alternations were needed
Some tape and wire, will represent a stretcher on one wall
Decontaminator or fire extinguisher, you choose
A bit of work is needed here as well
In the interior a lot of work took place. Pedals, window levers and door handles
I cut half of the hood, to have it half open, while I attached the opening levers on both sides. Τhe new dash is attached, the small co-drivers "table"as well
Off another Academy kit/set, I used a couple of gas cans, with some improvements
The door arches needed to be filled
The rear step was given in closed position. I need it open 😉
Kommentare
1 8 December 2014, 17:17
Dimitris P.K.
Hey Gary, thanks. The saw I used here, is this -> Nano Saw set (RB Productions RB-T038, No)
Hey Gary, thanks. The saw I used here, is this -> Nano Saw set (RB Productions RB-T038, No)
8 December 2014, 18:19
Dave Flitton
Nice work, I didn't know there were a lot of errors in the Academy kit.
Nice work, I didn't know there were a lot of errors in the Academy kit.
8 December 2014, 19:43
Dimitris P.K.
Thank you Dave. Unfortunately, for the vehicle I want to depict, there are issues.
Thank you Dave. Unfortunately, for the vehicle I want to depict, there are issues.
8 December 2014, 22:25