Polikarpov I-153
![Album image #1 Album image #1](/albums/img/2/8/3/851283-58861-63-720.jpg)
The Rigging is Infini Aero rigging. I pre-drilled all the holes and glued one end into the wing then pulled it through the fuselage until it was tight. This meant the engine and cowl were installed after the rigging was in place.
![Album image #2 Album image #2](/albums/img/2/8/4/851284-58861-73-720.jpg)
The kit decals went down with no issues.
![Album image #3 Album image #3](/albums/img/2/8/5/851285-58861-64-720.jpg)
The MG blast tubes and exhaust stubs are Albion Alloys micro brass tubing.
![Album image #4 Album image #4](/albums/img/2/8/6/851286-58861-14-720.jpg)
![Album image #5 Album image #5](/albums/img/2/8/7/851287-58861-81-720.jpg)
Of the three ICM Polikarpov models I built together, the I-153 had the best molding and least flash.
Kommentare
3 27 September 2020, 20:23