Sword BAC/EE Lightning T Mk.5

I found that there was an unacceptable gap between the wing and the fuselage. The gap was worse on the port wing due to the body being pinched. 

I had to resort to my engineering craft trade skills to solve the problem - Mark out for drilling a hole 

Choose a 3.3mm drill for tapping an M4 thread 

Tap M4 thread 

Fully insert a 4mm screw and jack out the fuselage side until the gap disappears  

Cut the screw after measuring the remaining protrusion  

fit the screw until its under flush 

The result is a smaller gap. not perfect because the jacking screw is too far forward from the largest gap but its not possible to fit it there due to the wing insertion lug