Johan 63 Olds
pretty nasty seam around the script
took some time but managed to got it off pretty well
the hood had some flash on the front, and I cut a bit too much on the left side
but hopefully it wont be too noticable after repairing
had 4 sink marks on the trunk. the ones towards the front I managed to sand out, the others i had to putty
Out of focus, but you can see how nicely centered the whitewalls are !!
They make the engine look SO good,,,,,
compare to what's really there.
The windshield gap is much worse than it looks here, but from the side you don't notice it. Next time I'll know to test fit the glass FIRST !!
AND, I had to fabricate the pipes between the headers & the exhaust. I just used some wire and painted it
Comentarios
1 18 March 2018, 18:14
Robert W Martel
Now I remember why, when I as a kid why we avoided the Jo-Han kits like the plague! When the Revell & AMT kits were $3 the Johan's were $1.29. They were just CHEAP kits. Unless it was of a car I really wanted, they did cars that the others didn't.
To start with it is super simple with very few parts, detail is ok, but things just aren't as good as the others.
I spent some time polishing the glass and got it looking pretty good, but when I went to put it in it fit so poorly and was so thick that it split the vent cowling under the windshield, Bummer! I spent hours sanding and polishing it (again) thin enough to fit! And the gaps in the lower corners are atrocious!
They all come with the same steering column mounted combination tach, shifter & blinker switch (chromed). This car had a t-handle floor shifter, but it was not included, even though there was a hole in the console for it. So I cut the shifter off the column and put it in the console.
The engine has no carb, the air cleaner sits on the distributor cap and if installed as designed the snorkel would point to the rear!, no radiator hoses, no outside mirrors, no antenna, pretty crummy looking whitewalls.
The basic detail isn't bad, it's just lacking the finer points, chassis is all molded as one piece as is the interior tub.
It really doesn't look bad, just lacks the finer details. When it's the only thing available for a certain car, there's not much choice but to grin and bear it and do the best you can with it.
I'm happy with it. I knew what to expect from the start.
It's another car that I had back in the days, and I'm just happy there was any kit for it at all. Now, the one I'd Really Like would be a 64 Olds Dymanic 88, but have yet to see any 64 Oldsmobiles, period.
Now I remember why, when I as a kid why we avoided the Jo-Han kits like the plague! When the Revell & AMT kits were $3 the Johan's were $1.29. They were just CHEAP kits. Unless it was of a car I really wanted, they did cars that the others didn't.
To start with it is super simple with very few parts, detail is ok, but things just aren't as good as the others.
I spent some time polishing the glass and got it looking pretty good, but when I went to put it in it fit so poorly and was so thick that it split the vent cowling under the windshield, Bummer! I spent hours sanding and polishing it (again) thin enough to fit! And the gaps in the lower corners are atrocious!
They all come with the same steering column mounted combination tach, shifter & blinker switch (chromed). This car had a t-handle floor shifter, but it was not included, even though there was a hole in the console for it. So I cut the shifter off the column and put it in the console.
The engine has no carb, the air cleaner sits on the distributor cap and if installed as designed the snorkel would point to the rear!, no radiator hoses, no outside mirrors, no antenna, pretty crummy looking whitewalls.
The basic detail isn't bad, it's just lacking the finer points, chassis is all molded as one piece as is the interior tub.
It really doesn't look bad, just lacks the finer details. When it's the only thing available for a certain car, there's not much choice but to grin and bear it and do the best you can with it.
I'm happy with it. I knew what to expect from the start.
It's another car that I had back in the days, and I'm just happy there was any kit for it at all. Now, the one I'd Really Like would be a 64 Olds Dymanic 88, but have yet to see any 64 Oldsmobiles, period.
10 June 2018, 23:20
Robert W Martel
Thanks Tom. If it was a better kit I probably would have put a bit more effort into it. And it was a car that I only had for a very short time and didn't really care much for. They were great looking cars though, back then ! Cheers
Thanks Tom. If it was a better kit I probably would have put a bit more effort into it. And it was a car that I only had for a very short time and didn't really care much for. They were great looking cars though, back then ! Cheers
12 June 2018, 01:06
Tom Ballhoff
Hi Robert, I always see that the old rarities certainly have their charm and as such in this day and age of perfectionism can be built just like that, without much etched parts, etc.
Hi Robert, I always see that the old rarities certainly have their charm and as such in this day and age of perfectionism can be built just like that, without much etched parts, etc.
12 June 2018, 09:46
Robert W Martel
Yup! gotta work with what ya got. I have quite a few OLD kits of cars that I had. There are PE for a few of them. Mainly I want just the scripts like for my Windsor project. I have found LeMans scripts for my 64 & 68 GTOs, and a few others I can use maybe, but it seems they only make for the real common ones!
Yup! gotta work with what ya got. I have quite a few OLD kits of cars that I had. There are PE for a few of them. Mainly I want just the scripts like for my Windsor project. I have found LeMans scripts for my 64 & 68 GTOs, and a few others I can use maybe, but it seems they only make for the real common ones!
21 August 2018, 05:59
Christian W
This is a very nice, old kit. I like to see this rare kits built. Very nice.
This is a very nice, old kit. I like to see this rare kits built. Very nice.
8 June 2020, 06:22
Robert W Martel
Thanks Christian, I only had this car for a short time, but since the kit was reasonable I thought, why not?
Thanks Christian, I only had this car for a short time, but since the kit was reasonable I thought, why not?
10 June 2020, 04:29
Christian W
Sure! If I'd get a model kit of each car I had, I'd buy it. But the most Honda aren't available 🙁
Sure! If I'd get a model kit of each car I had, I'd buy it. But the most Honda aren't available 🙁
10 June 2020, 08:53
wilky
I recently purchased a kit of a car I owned but being Australian nobody makes kits for any of the other cars I've owned.
I recently purchased a kit of a car I owned but being Australian nobody makes kits for any of the other cars I've owned.
10 June 2020, 09:44
Robert W Martel
That's a bummer wilky! I know the Aussie cars were different, even the Fords weren't the same as the US versions.
That's a bummer wilky! I know the Aussie cars were different, even the Fords weren't the same as the US versions.
11 June 2020, 19:28
wilky
Yeah, we're pretty much a forgotten country by kit manufacturers.
Obviously not the only one though.
When I was a kid there were virtually no kits of aircraft that Australia used either.
Airfix had made their version of the Boomerang but I wasn't old enough to had seen that on the shelf.
Currently there's a kit maker called The Parts Box that does Australian cars and I'm hoping to get some of their kits soon.
Especially their Mad Max Interceptor
Yeah, we're pretty much a forgotten country by kit manufacturers.
Obviously not the only one though.
When I was a kid there were virtually no kits of aircraft that Australia used either.
Airfix had made their version of the Boomerang but I wasn't old enough to had seen that on the shelf.
Currently there's a kit maker called The Parts Box that does Australian cars and I'm hoping to get some of their kits soon.
Especially their Mad Max Interceptor
11 June 2020, 19:51
Robert W Martel
That's a bummer wilky. Funny, Of all the places, Australia is the place I've always wanted to go.
Yea !!!! I STILL WANT an Interceptor!!! !!! !!!!!
That's a bummer wilky. Funny, Of all the places, Australia is the place I've always wanted to go.
Yea !!!! I STILL WANT an Interceptor!!! !!! !!!!!
14 June 2020, 03:53
Robert W Martel
ooooh!!!!!Looks like a pretty nice kit but pretty pricey! $113 for a car kit! Plus sipping I'm sure would be another 20-30 bucks. OUCH!!!! Is that plastic or resin??? Well, It's gonna have to be lower down on the list for now. Looks like a pretty nice kit though. Plus decals are separate. You're looking at $150 car !!!!
Which movie would that one have been in???, was that "the last of the V8s!"? But no real engine either. EICH E WOW A !!! lol
ooooh!!!!!Looks like a pretty nice kit but pretty pricey! $113 for a car kit! Plus sipping I'm sure would be another 20-30 bucks. OUCH!!!! Is that plastic or resin??? Well, It's gonna have to be lower down on the list for now. Looks like a pretty nice kit though. Plus decals are separate. You're looking at $150 car !!!!
Which movie would that one have been in???, was that "the last of the V8s!"? But no real engine either. EICH E WOW A !!! lol
14 June 2020, 19:46
wilky
First movie car.
Yeah, not cheap but then those Aoshima kits are 400AUD and they also don't have an engine.
It's because the blower was fake.
Bolted to a platform above the engine
First movie car.
Yeah, not cheap but then those Aoshima kits are 400AUD and they also don't have an engine.
It's because the blower was fake.
Bolted to a platform above the engine
14 June 2020, 20:16
wilky
The Parts Box kit to me isn't any different to a Johan kit.
There's a Johan '70 Oldsmobile kit for sale on eBay located in Australia right now 99.99 + 8.95 Aussie Dollars.
All the other Johan kits are located overseas and with shipping and tax are more expensive than that.
As you say they're not very good kits and I've never owned an American car so have absolutely no appeal to me.
I've actually owned an Interceptor, not the Black on Black Pursuit Special Interceptor but the yellow, red, white and blue four door Interceptor in the opening scene. Call sign March Hare.
I purchased a Ford XA Falcon and painted it myself back in the eighties because Mad Max is my favourite movie of all time.
As an Aussie being ripped off is just an everyday occurrence but there's things about being an Aussie that no other country has.
Where I live I can leave the keys in the ignition of my car and it's still there the next morning.
Since I paid over 600AUD for my Vintage Fighter Series P-40 a 150AUD isn't so bad but I understand with the prices of kits for you it's expensive
The Parts Box kit to me isn't any different to a Johan kit.
There's a Johan '70 Oldsmobile kit for sale on eBay located in Australia right now 99.99 + 8.95 Aussie Dollars.
All the other Johan kits are located overseas and with shipping and tax are more expensive than that.
As you say they're not very good kits and I've never owned an American car so have absolutely no appeal to me.
I've actually owned an Interceptor, not the Black on Black Pursuit Special Interceptor but the yellow, red, white and blue four door Interceptor in the opening scene. Call sign March Hare.
I purchased a Ford XA Falcon and painted it myself back in the eighties because Mad Max is my favourite movie of all time.
As an Aussie being ripped off is just an everyday occurrence but there's things about being an Aussie that no other country has.
Where I live I can leave the keys in the ignition of my car and it's still there the next morning.
Since I paid over 600AUD for my Vintage Fighter Series P-40 a 150AUD isn't so bad but I understand with the prices of kits for you it's expensive
14 June 2020, 20:45
Album info
Another of the cars I had. Mine was just an 88 black hardtop. I didn't have it long. I bought it in the winter and the heater leaked, so when I turned on the defroster it just fogged up the windshield worse and smelled like antifreeze! I think I paid like $35 for it. I traded it for a 56 Plymouth Savoy.