My Mirage 2000C Finished
The canopy is not positioned correctly, the visor of the dashboard is too thick, it will be necessary to refine this
I sanded the underside of the visor and retracted it to limit the risk of interference with the canopy
the rendering of the nozzle is correct, in resin it must be thinner ... but it increases the cost of the kit
the two generations of Dassault deltas, they are almost the same size!
Decals Ok, Just a little strip of hatched decal to pick up
And here he is on his feet
I put the traces of hydraulic fluids
once all the probes and antennas are in place, I don't know where to handle it ...
there are even two probes at the bottom of the fin, one on each side
there are also the antennas, and one of the probes on the cockpit ends has already disappeared ... found and to be re-glued!
An ejection seat to finish plus a stroke of satin varnish and this 2000P mirage will be finished.
Comentarios
17 4 April 2021, 19:16
Prieur Gaël
It is a very easy and pleasant assembly, no trap for the moment.
I used the color of the cockpit which is not black for the first machines but blue gray (gunze H337)
It is a very easy and pleasant assembly, no trap for the moment.
I used the color of the cockpit which is not black for the first machines but blue gray (gunze H337)
4 April 2021, 19:25
Prieur Gaël
merci laurent
@Maciej I loved to see the french airplane with exotic scheme
merci laurent
@Maciej I loved to see the french airplane with exotic scheme
17 April 2021, 17:48
Laurent VILLANUEVA- "HELLER ForEver"
pas eu trop de mal avec la découpe du kit ( dessous? )
pas eu trop de mal avec la découpe du kit ( dessous? )
19 April 2021, 16:47
Prieur Gaël
Non pas trop, il me sert de montage de déverminage, je repère des trucs pour ceux qui suivront,comme limer certaines parties des entrées d'air (sur le dessous) qui gène un peu la bonne pose du ventre et crée une petite marche juste derrière la case de tain
Non pas trop, il me sert de montage de déverminage, je repère des trucs pour ceux qui suivront,comme limer certaines parties des entrées d'air (sur le dessous) qui gène un peu la bonne pose du ventre et crée une petite marche juste derrière la case de tain
20 April 2021, 17:33
Laurent VILLANUEVA- "HELLER ForEver"
ok...la découpe du bas est bizarre , mais sinon le kit est très détaillé
ok...la découpe du bas est bizarre , mais sinon le kit est très détaillé
20 April 2021, 18:35
Album info
modelsvit, 1/72