Uutisvirta
ismojveromistaa tämän kohteen
ACES II ejection seat – Type B For F-15A/C/E, A-10A, F-117 & F-22 (two per pack)
Aires 1:48
4144 2004 Uusi työkalu 14 August, 06:39
littleblackbearlisäsi uuden valokuva-albumin.
1 kuvien
Scratch-Built Dutch House
1:35
Experimenting with foamed PVC
projekti: "Market Garden" Netherlands 1944
6+14 August, 02:53
giuseppe lorussolisäsi uuden valokuva-albumin.
11 kuvien
Ferrari 360 Modena Challenge 2000
1:24
projekti: Ferrari 360 Modena Challenge 1999 msc
9+ 3 13 August, 17:47
ismojveromistaa tämän kohteen
Phantom F-4J seamless intakes for Hasegawa kit
Alley Cat 1:48
AC48030C 14 August, 06:37
Llyrvalmistunut tämä esine
Supermarine Spitfire & F-35B Lightning II Then and Now
Airfix 1:72
A50190 2023 Mallijoukko Multi-aihe (2)14 August, 06:18
bossy122lisäsi uuden valokuva-albumin.
5 kuvien
Peugeot 206 2000 Rally San Remo Panizzi
1:24
Credit to whomever I bought the kit from for doing the carbon on the seats.
projekti: Peugeot 206 2000 Rally San Remo Panizzi
10 5 July, 20:08
Martin OostromCan't you strip the sprues as a whole of the paint? Dip them in a bath of paint stripper? Might be a whole lot easier than sanding each piece
9 July, 06:15
bossy122Most of the pieces are under carriage, so they're not that visible......but I stay awake at night knowing there are seams and that they must be eliminated! I think I botched the body paint job and I hadn't noticed on its original project. I just went over the lint - think HAIR - with 600 to 2000 and that took care of it. Mostly, I just thought it was funny that whomever I bought this kit from had gone to that much trouble to paint pieces ON the sprues with a brush, only to be done over with a rattlecan OFF the sprues.
9 July, 06:23
Martin OostromI feel your pain. I'm currently sanding tanks on a truck. Tanks that will never be seen, yet I've spent a few hours already on them.
9 July, 06:25
bossy122The TS4 German Grey isn't nearly dark enough for the dash. Or, the actual color of the dash should be black, but the instructions called out for German Grey......I dunno, Tamiya.
12 August, 06:51
BozzerSometimes, it's easier to use a thin Sharpie, for knobs and buttons. It dries fast, so if you make a mistake, you can touch up, more or less, straight away. I also use a Sharpie for window rubbers, etc
14 August, 00:07
/fi/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=fi
35
35
/fi/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo