Mazda RX-7 NFSU2 - Wip

First, I covered the model with paper tape so that the body could be "scanned". 

 

 

 

And the model is now in the computer. 😄 

Body kit that I want to adapt to the model. 

In the process of creating a 3D model. 

 

 

The front bumper is trimmed and later the front spoiler as well. 

 

 

The front suspension was poorly assembled by the previous owner. 🙁 

 

After completing the 3D models, I ordered them to be printed. 

And here is the first fitting, almost everything is fine. 

 

 

 

 

 

 

 

 

 

 

 

 

Now, on the contrary, the car from the computer has become physical. 😄 

In the end, I had to modify only the 3D models of the rear bumper, muffler and rim, all other 3D models fit the first time. 

 

The body kit is glued with super glue and soda. 

The doors was filled with putty. 

 

 

 

 

After gluing the body kit, it was necessary to apply more putty. 

 

 

The rear bumper gap is filled with putty, but the front one is not. 

 

 

 

 

 

 

 

 

The exhaust fits perfectly.