Peugeot 206 2000 Rally San Remo Panizzi
Kommentit
10 5 July, 20:08
![](/profiles/img/28909-839-s.png)
Can't you strip the sprues as a whole of the paint? Dip them in a bath of paint stripper? Might be a whole lot easier than sanding each piece
9 July, 06:15
![](/profiles/img/user-s.jpg)
Most of the pieces are under carriage, so they're not that visible......but I stay awake at night knowing there are seams and that they must be eliminated! I think I botched the body paint job and I hadn't noticed on its original project. I just went over the lint - think HAIR - with 600 to 2000 and that took care of it. Mostly, I just thought it was funny that whomever I bought this kit from had gone to that much trouble to paint pieces ON the sprues with a brush, only to be done over with a rattlecan OFF the sprues.
9 July, 06:23
![](/profiles/img/28909-839-s.png)
I feel your pain. I'm currently sanding tanks on a truck. Tanks that will never be seen, yet I've spent a few hours already on them.
9 July, 06:25
![](/profiles/img/user-s.jpg)
The TS4 German Grey isn't nearly dark enough for the dash. Or, the actual color of the dash should be black, but the instructions called out for German Grey......I dunno, Tamiya.
12 August, 06:51
![](/profiles/img/48725-851-s.jpg)
Sometimes, it's easier to use a thin Sharpie, for knobs and buttons. It dries fast, so if you make a mistake, you can touch up, more or less, straight away. I also use a Sharpie for window rubbers, etc
14 August, 00:07