Revell F-102A Delta Dagger
Left side intake complete. Sanding and filling required. Used Perfect Plastic putty.
Rights side intake. Had to add some plastic card to close up the gap.
Wing sections joined. Filler needed around the entire perimeter.
Sanding and more sanding. Added some Tamiya Thin "Gloop" to close up the gap.
Lots of pre-assemblies. Cockpit has been painted even though you can’t tell.
Kommentit
23 October 2019, 01:55
Bryn Crandell
All of the pre-assemblies are done I hope. Starting to get things painted.
All of the pre-assemblies are done I hope. Starting to get things painted.
25 October 2019, 02:16
Erik Leijdens
Good start Bryn! I have this one too but I'm in doubt of rescribing it or not. Will follow yours Bryn!
Good start Bryn! I have this one too but I'm in doubt of rescribing it or not. Will follow yours Bryn!
25 October 2019, 07:54
Bryn Crandell
Lost a bunch of photos. So here are photos of the completed bird. I feel it came out nicely. It has joined it F-106 brother on the shelf.
Lost a bunch of photos. So here are photos of the completed bird. I feel it came out nicely. It has joined it F-106 brother on the shelf.
12 March 2020, 01:47
Donald Dickson II
Yeah, that's a bit of a jump from partial assembly to finished. LOL Great job!
Yeah, that's a bit of a jump from partial assembly to finished. LOL Great job!
12 March 2020, 04:55
Bryn Crandell
@Donald Yeah no doubt. I am looking for the other photos so that I can at least load them up. lol
@Donald Yeah no doubt. I am looking for the other photos so that I can at least load them up. lol
12 March 2020, 11:46
Slavo Hazucha
Definitely came out nice 👍 Looking good all clean & colorful! Good job on both this & the 106
Definitely came out nice 👍 Looking good all clean & colorful! Good job on both this & the 106
12 March 2020, 13:29