Saturn V 2.0
![Album image #1 Album image #1](/albums/img/1/3/2/1659132-15981-58-720.jpg)
The F1 engine from the kit. The seam was a bit too much for me, so....
![Album image #2 Album image #2](/albums/img/1/3/3/1659133-15981-76-720.jpg)
...the 3D printer was brought in to help out!
![Album image #3 Album image #3](/albums/img/1/3/4/1659134-15981-72-720.jpg)
F1 engine plumbing, fresh off the printer. There are 6 of each component, even though there are only 5 engines. I try to print an extra 1 or 2 of smaller parts, just in case.
![Album image #4 Album image #4](/albums/img/1/3/5/1659135-15981-59-720.png)
This is one of the fuel delivery pipes in MeshMixer. Note the thin red line in the center. It is showing the measurement of the hole. The numbers on the right are the measurement. High, Average, Low from top to bottom. Less than half a millimeter. I wasn't sure how it would turn out on the printer.
![Album image #5 Album image #5](/albums/img/1/3/1/1659131-15981-93-720.jpg)
Turns out, I needn't worry! Picture isn't the best but the holes are just about perfect!
![Album image #6 Album image #6](/albums/img/1/3/0/1659130-15981-98-720.jpg)
Details that will never be seen but still there. Inside the combustion chamber.
Commentaires
4 9 February, 14:40
Album info
Let's start at the beginning, shall we?