Testors Dornier Do-24T
parts in box
cockpit and stub wings
horizontal stabilizer
right wing and center section
full wing together
elevators and seats installed
wing over my C-130 for scale perspective
fuselage beside C-130
cockpit complete
Control columns painted RLM66
main wing seams puttied
stub wing and tail top surfaces primed
bottom surfaces primed
cockpit installed
wing seam work
right upper wing primed
wing top surface primed
par tof bottom primed
entire wing primed
RLM82 on stub wings and tail
RLM82 on part of wing top
wing top all RLM82
bottoms in RLM76
assembling the nacelles
working on engines
engine nacelles and wing hinges
engines on the wing
fuselage together with turrets in
stub wings and horizontal tail on
vertical tails on
replacement gun from Brassin
slow progress
middle turret in
all turrets done fuselage closed again
closing up gaps
seams sanded and primed
RLM80 base coat on top
sprayed the bottom
top of wing decal progress
wing bracing strut attached
careful setting of the wing on the struts
filling seams again
seams cleaned up the bottom and RLM78 back on
vertical tail piece back on
Commentaires
28 June 2015, 01:40
Erwin BOVYN
Good luck on this one, still busy on mine. Can recommend the Eduard PE set for this aircraft.
Good luck on this one, still busy on mine. Can recommend the Eduard PE set for this aircraft.
2 July 2015, 05:27
Thomas Bischoff
another Dornier in the making ... only one tiny critic: if you use e.g. a sheet of white paper as a background it would make all the difference.
another Dornier in the making ... only one tiny critic: if you use e.g. a sheet of white paper as a background it would make all the difference.
13 February 2016, 08:17
Erwin BOVYN
Look out for the gap between cockpit and body. The cockpit in the Italeri version (probably the same as Testors) is a big too wide.
Look out for the gap between cockpit and body. The cockpit in the Italeri version (probably the same as Testors) is a big too wide.
13 February 2016, 15:26