MiG-19PM -
1
August 22, 2016In a kit consisting of the missing Resin cockpit tub, so I built with a plastic itself. The lack of this seat comes from my stash.2
August 22, 20163
August 22, 20164
August 22, 2016For the blowing stations are the etchpart the burner rings available. Unfortunately, the plastic part is in scope too far, and so does not fit in the trunk. Here's hip grind.5
August 22, 2016Lead bullets from the fishing equipment is to prevent later tailsitting. Meanwhile the cockpit tub was installed, but here diverse adaptation work was necessary.6
August 22, 2016As the "S" equipped a shorter fuselage and the blowing plant inlet without radar, the corresponding parts have been cut by sawing.7
August 22, 2016Since the "PM" had no cannons that parts were removed at the wing roots.8
August 22, 2016In addition, it should appear in the landing state. Therefore, all valves were sawn.9
August 24, 2016The sawing going on. The rear part of the canopy was sawn off, as this is an integral part of the hull and was also placed there.10
August 24, 2016Furthermore, the horizontal stabilizers were divided. There are pendulum tail, these were also completely isolated.11
August 24, 2016Since I had just black paint in the airbrush, I took the opportunity, the two jets times precoat to make possible flaws visible.12
August 24, 2016In addition, the flying version to get a pilot. This is made from resin and has been slightly adapted to fit into the narrow cockpit. was complemented the straps from the etchparts. He can run no longer, unfortunately, he does not have to also. Nothing is13
August 31, 2016Despite his lopsided grin, the pilot did not equal the cockpit. But the pressure of the government he could not be challenged.14
August 31, 2016Only the red ejector seat strap on top and a small glass panel in the cockpit and there you go. For heating the pulpit was also worried.15
August 31, 2016Pulpit it, so he does not get drafts. Now taping begins.16
October 12, 201617
October 12, 2016For the other pulpit, which should be shown open, the rear panel with heating cable (?) Was scratched.18
October 12, 2016After the pulpits have been treated with Colorstop, the actual painting can start.19
October 12, 2016All the rudders and flaps were added.20
October 12, 2016The MiG's were painted with aluminum color. As a small test for the PM the aluminum color 27002 from Humbrol and the S with ModelMaster II used.21
October 12, 2016The latter gives a better picture and can be painted better. However, it is also more susceptible to grip.22
October 12, 2016After mounting the decals of Tom's model building,23
October 12, 2016the small aps and the pylons were built.24
October 20, 201725
October 20, 201726
October 20, 201727
October 20, 201728
October 20, 201729
October 20, 2017
Commentaires
3 22 August 2016, 20:38
Album info
36 images