Winnie Mae - Lockheed Vega 5

1
January 1, 2021
2
November 12, 2020
3
November 10, 2020
The nose decal was a tough fit. Lots of Micro Sol, along with some small cuts in the decal, did get a decent result.
4
November 20, 2020
This is the kind of fix that folks here have inspired....seeing what others can do lets a guy see what is possible. The inspiration is continuous....even for a little fix like this...never would have tried this in the past.
5
November 20, 2020
6
December 13, 2020
The Wiley Post version is back underway. Progress was good on the landing gear setup but the panel line work on the flaps is not great.
7
December 17, 2020
This is a sad modeling story....because there was a small flaw in the overcoat…that became a large flaw...the entire fuselage was stripped and will be redone...hopefully, the hard work on the cockpit will be saved and the harvested canopy from the old build can be added after the fact.
8
December 18, 2020
9
December 29, 2020
re-masking for the fourth paint try...practice makes perfect...lets hope...
10
December 29, 2020
First coat of the lighter blue....that decal is the model for the shape...two more coats to go
11
December 30, 2020
The big wing unveil after 4 attempts....You know, it actually worked, sort of, this time.

I took advice from Aaron Skinner and did not "seal" the edge with clear primer for the session.

Later came touch up, and the paint sealed with Microscale Gloss. Decals, detail painting and panel lines are next.
12
December 30, 2020
The State of play of the Winnie Mae....a modeling rhyme....

....there are so many ways this dude isn't up to snuff..

..the cockpit...the paint that "matched" when tested, but not when sprayed!...by golly, i am going to get decent looking wheel spats...but i have to learn to sand curves....

...folks....there are more "lessons" in this little model....

...it is time to do the best i can and move on...but, i AM going to fill in those spats and try to make better versions....honestly, this has been a fun project....but it is time to move on...
13
January 2, 2021
Happy chaos in 2021!

.....have a great year, everyone
14
February 1, 2021
15
February 1, 2021
16
February 1, 2021
17
February 1, 2021
18
February 1, 2021
19
February 1, 2021
20
February 1, 2021
21
February 1, 2021
22
February 1, 2021

Commentaires

15 10 November 2020, 06:56

Lochsa River
The Wiley Post Version of the Vega Project has restarted

10 November 2020, 07:12

Gordon Sørensen
The decalling looks good! Saw the real one at the Smithsonian a few years ago. The display is kinda crowded, the plane is raised up and visible but not easily photographed...

10 November 2020, 17:06

Lochsa River
GOOD NEWS...BAD NEWS...See PHOTO....had to redo the wing and fuselage...but the cowling is ok

12 November 2020, 18:42

Lochsa River
BACK IN THE SADDLE AGAIN....

13 December 2020, 04:45

Cuajete
Looking very good. Well done so far!
Interiors are empty?

17 December 2020, 19:52

Lochsa River
Gracais. Yes....this is a series of Vegas and i decided to forego the interiors because they add very little.

Here is a link to the Vega page on my website:

bobsmodelcollection...ng/vega%20series.htm

17 December 2020, 20:06

Dave Flitton
Watching

17 December 2020, 20:43

Lochsa River
After failing with decals...the big wing blue section gets masked and paint...we will see....

21 December 2020, 05:24

Lochsa River
This little guy is now on its third attempt to paint a blue top wing section, after two failed decal efforts....

I've never had anywhere near this much trouble getting a good mask....the first attempt was a complete failure so i worked extra hard, cutting fresh mask tape edges and being sure to burnish the edges as best i could, with a clear primer coat to "seal" the edge, all with a lowered PSI from the compressor...and it was only a bit better.

Maybe its the blue paint....just too much needed for one coat over the insignia white coat and it was bleeding out...?

One more time...this time I will only put a light coat of paint on, let it dry thoroughly and put another coat on later...as many light coats (which hopefully won't bleed out) as it takes.

Wish me luck!

25 December 2020, 02:52

Pierre Pierre
following

25 December 2020, 09:58

Pierre Pierre
we are we you, courage and determination !

25 December 2020, 10:06

Lochsa River
It is not obsession...it is a hobby.

So that explains deciding a perfectly decent wing blue section was too dark and not the right color, even though it took three tries to get there....so, a decision has been made to make a custom color for the wing....

...5 parts Mission Models MMP-001 White and just 2 parts MMP-048 Blue make a pretty good match for the FS25184 color that no one seems to make.

....all the lessons learned from finally getting a good mask, etc. will be used on this, now fourth, attempt to paint the wing section...repeat after me...it is just a hobby....

28 December 2020, 05:53

Lochsa River
The State of play of the Winnie Mae....a modeling rhyme....

....there are about twelve different ways this dude isn't up to snuff..

..the cockpit...the paint that "matched" when i tested it but not when i sprayed it!...by golly, i am going to get decent looking wheel spats...but i have to learn to sand curves....

...folks....there are more "lessons" in this little model....

...it is time to do the best i can and move on...but, i AM going to fill in those spats and try to make better versions....honestly, this has been a fun project...but it is time to move on...

30 December 2020, 06:01

Cuajete
Well done 👍.

30 December 2020, 19:02

Lochsa River
Happy chaos in 2021...see photo....have a great year, everyone

2 January 2021, 04:49

Cuajete
Happy New... Chaos! 👍

2 January 2021, 19:06