Hírfolyam
Krzysztofúj fotóalbumot adott hozzá.
40 képek
Messerschmitt Bf 110
1:48
Messerschmitt Bf 110 E-2. Painting C: Lt. Felix-Maria Brandis, 1.(Z)/JG 77, Malmi, Finland, 1942. Plastic 1:48 scale mod...
Projekt: Messerschmitt Bf 110
41 24 February, 19:24
Tcampúj fotóalbumot adott hozzá.
13 12 September, 12:10
TcampThank you sir.
The deck wire is ez line my 1st experience with it ( that stuff is awesome!)
Conning tower is brass 1/200 railing ( from timos-modelworld)
13 September, 11:38
TcampYpu know most builds are of the gato 212 i wanted to pay homage to those that gave ultimate sacrifice i never heard of the albacore before found it researching she hit a mine and lost with all hands. But on that same patrol she sunk a carrier. So anyway i had the numbers they are out of scale and in actuality would not be on the bow during patrol but they tie the kit to the nameplate. For me when the styrene scales tip they tip on the side of artistic licsense ( lol).
Anyway thats how that came to be. I wanted something different.
13 September, 21:19
TcampSeems every one builds the gato i wanted something different
And pay homage to the ultimate sacrifice she hit a mine and lost with all hands.
Hull numbers i had not to scale and would actualy not be on bow on patrol but ties sub to name plate.
I played myvartistic licsense card ( lol )
13 September, 22:26
Hang Liúj fotóalbumot adott hozzá.
26 24 June, 07:48
Thomas WirschingGreat job so far! I would love to get an explanation about how to do these LED lighting in detail as I have no idea about this.
8 July, 05:04
Hang LiThanks Tim, Villiers, and Thomas. I did put a led for the trolled sonar bay back at the stern. It is apparently not bright enough to be really visible. Probably not noticeable after finished.
I prefer to use Led tape light as it has build in resistors so I don't need do calculation to figure out the resistor value. Once that is sorted, what left is just connect the led unit with a battery and a switch. I think it is better to ask a trained electrician as the circiut I built don't last long and I don't really know why.
9 July, 12:37
Michael KohlI expect modelling of the highest quality from your bench. So far I am not disappointed. 🙂
Keep it up.
6 August, 09:58
TreehuggerHm, how long did it take to make the nice looking ocean surface? It certainly looks like a fun project.
I wish I knew how to make such ocean surfaces, as it really seem to complete a model with such a diorama.
I am no expert on led's but my impression is that one has to be careful that the voltage to the led's is controlled to specs, so they don't burn out shortly after and end up being un-repairable inside the model. Also, something about connecting led's in parallel, pattern iirc, to avoid one dead led blacking out all the rest of the leds in a serial connection, iirc.
25 August, 09:36
Hang LiThanks Treehugger, THomas and Tim.
As for the sea base, you can check a YouTube channel called ''studio blue ocean'', I basically followed his videos. And treehugger did a pretty good summary for LEDs. The voltages is very important and it is always needed to put some resistors in series to potect the LEDs. The size of the resistors can be calculated with ohms' law. There are small circuit boards for LEDs which can be used to make everything easier.
8 September, 12:51
Jorge Avilaúj fotóalbumot adott hozzá.
103 képek
Triple Nickel Growler in progress 
1:32
A general view of the major components and the built-up wings with the new aftermarket set from Flight Line Resin.
Projekt: Triple Nickel EA-18G Growler
14+ 22 5 July, 07:33
Andrewmegszerezte ezt
Armament for Soviet heavy tank T-10M:
122 mm M62-T2 gun barrel + 14.5 mm KPVT gun barrel fit to Meng / Trumpeter Aber 1:35
35L182 2016 Új eszköz 13 September, 22:23
James Cúj fotóalbumot adott hozzá.
39 képek
Panzerkampfwagen I Ausf.B
1:16
Paintwork sealed with a protective coat of clear gloss and decals applied.
Projekt: Panzerkampfwagen I Ausf.B
13 30 August, 22:31
James CHave decided on my next victim, so pulled this one out of the stash this morning and gave the parts a rinse to clean off the mold release agents etc. Hope to make a start on it in the next day or so once dried. Similar to the Panzer 1A that I built previously, but this one is slightly longer due to having an extra road wheel, as well as a modified rear engine deck and exhaust due to having a different engine. Haven't decided if it will be based in France or Greece yet, but definitely leaning towards the grey and brown camouflage per the box art.
30 August, 22:32
John HughesI'd recommend adding the superstructure from front to back as you can have alignment issues. You can get decals for the fire extinguisher, which are not in the kit.
6 September, 11:43
James CThanks guys 🙂
Really enjoying the larger 1/16 scale, and finding them much easier on the eyes to assemble.
Thanks John and yeah, that's what I did with the "A" version I built previously.
6 September, 19:35
James CI got quite a bit more done today with both track runs mounted for a test fit. They worked out quite well in the end, being much better than the plastic links that come in the kit. Far easier to assemble as well as only took a couple of hours versus several days for the stock plastic parts. Adds a nice bit of weight to the model as well. Still need to adjust the tension a little to get them sagging properly but pretty happy with how they turned out. Started to loose the natural lighting so will leave the turret assembly and smaller detail parts for tomorrow.
7 September, 01:13
James CFinished off the assembly a little while ago. Just needs a little clean-up in a couple places before I tear it apart again to airbrush a coat of black primer on it. I'm hoping it will be a little warmer tomorrow which will help with drying times. Am also considering adding an extra link to both track runs as in hindsight the tracks look a little tight at present with 97 links.
9 September, 01:58
Andrewmegszerezte ezt
Post-WWII Soviet
T-10M Heavy Tank Track Covers for Meng TS-018 Voyager Model 1:35
PEA364 2015 Új eszköz 13 September, 22:21
/hu/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=hu
35
35
/hu/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo