Hírfolyam

Alex K
In! Good luck!

Chris
Thank you! I have still noticed, that that will not be an easy-cheesy plane. You will see, what comes out.

Cuajete
Following!

Nicolas
I'll take a seat.

Dave Flitton
Watching!!

Ben M
💺

Chris
... well, may I serve some drinks? Chips? Sweets? Have fun watching my troubles.

The first problems arose today when I tried to install the frames. There are no markings or reference points for this. So it was a case of guessing and sanding. And then I forgot to take a photo of it... It'll come.

Ben M
I've heard rhese old Williams brothers kits are terrible. I have a couple I'm looking forward to building.

Ben M
Okay looking at this kit's timeline it was most recently issued by "s&m models." You can't make this stuff up.

Łukasz Gliński
Oh, cool, will watch

Robert Podkoński
Watching too.

Dave Flitton
Looking good. How's the fit?

NLAWScametovisit
nice work! I've been really tempted to pick up this kit. Would you recommend it?

Dave Flitton
Wondering if there were any issues with this kit.

Frank Brzobohaty
NAXOS receiver done and front engine too.

Dave Flitton
Nice start!!

Gerald
Hello Welcome here 🙂

Nich S
Thank you!! Great website, ive been using it for ages but i finally made an account

Tim
NIce

Villiers de Vos
Steady progress. Did you light the stern?

Thomas Wirsching
Great job so far! I would love to get an explanation about how to do these LED lighting in detail as I have no idea about this.

Hang Li
Thanks Tim, Villiers, and Thomas. I did put a led for the trolled sonar bay back at the stern. It is apparently not bright enough to be really visible. Probably not noticeable after finished.

I prefer to use Led tape light as it has build in resistors so I don't need do calculation to figure out the resistor value. Once that is sorted, what left is just connect the led unit with a battery and a switch. I think it is better to ask a trained electrician as the circiut I built don't last long and I don't really know why.

Michael Kohl
I expect modelling of the highest quality from your bench. So far I am not disappointed. 🙂
Keep it up.

Treehugger
Hm, how long did it take to make the nice looking ocean surface? It certainly looks like a fun project.
I wish I knew how to make such ocean surfaces, as it really seem to complete a model with such a diorama.

I am no expert on led's but my impression is that one has to be careful that the voltage to the led's is controlled to specs, so they don't burn out shortly after and end up being un-repairable inside the model. Also, something about connecting led's in parallel, pattern iirc, to avoid one dead led blacking out all the rest of the leds in a serial connection, iirc.

Thomas Wirsching
Your build is already mindblowing; 漂亮]!

Tim
Your sea base is looking really nice.