HA-1.112-K1L Buchón 1:32
1
February 13, 20242
February 13, 20243
February 13, 20244
February 13, 20245
February 13, 2024good fit in the 3d printed parts6
February 13, 2024Interior parts specifically designed for this buchon7
February 13, 2024Gunsight8
February 13, 2024Main panel, note the detail achieved.... but I'm not sure if I would be able to paint it
9
February 13, 2024Rocket launcher box10
February 13, 202411
February 13, 2024printed parts in place12
February 13, 202413
February 13, 202414
February 13, 202415
February 13, 202416
February 13, 202417
February 13, 2024aded some detail in the ruder pedals18
February 13, 202419
February 13, 2024Some wires to add detail20
February 13, 2024instrument panel and rocket box almost painted21
February 13, 202422
February 13, 202423
February 13, 2024panel ready24
February 13, 202425
February 13, 2024Rocket launcher box ready
26
February 13, 2024starting to play with interiors
27
February 13, 2024need some washes but is close to finish28
February 13, 202429
February 13, 202430
February 13, 202431
February 13, 202432
February 15, 2024internal face of the canopy painted in interior colour33
February 15, 2024Cockpit weathered34
February 15, 202435
February 15, 202436
February 15, 202437
February 15, 202438
February 15, 20243d printed Buckles for the seatbelts39
March 11, 202440
February 15, 2024seatbelts made with thin metal foil and the 3d printed buckles41
February 19, 202442
February 19, 202443
February 19, 202444
February 19, 202445
March 11, 202446
March 11, 202447
March 11, 2024dry test fit of the nose
48
March 11, 202449
March 11, 202450
March 11, 202451
March 11, 2024thinlayer of paint to unify colours and check for imperfections52
March 11, 202453
March 11, 2024quine nice here54
March 11, 2024some minor imperfections on the panel lines should be repaired55
March 11, 202456
March 11, 2024the stitching on the rudder seems too big, I will sand it down a bit to improve it
Hozzászólások
7 13 February, 19:37