makett adatbázis | polc kezelés
Silenoz
Bart Goesaert (Silenoz)
BE

FREMM CARLO MARGOTTINI F592 Frigate

Hozzászólások

28 February 2018, 12:03
Bart Goesaert
started this one, main parts have some serious misalignment problems, so a lot of sanding ahead. What is the best way to deal with the "ribs" from printing on the surfaces?
28 February 2018, 13:31
Patrick Hagelstein
Bart, what I once read was to pour a little aceton in a container and have the model suspended above the liquid for a few minutes. Aceton vapor is heavier than air and will form a layer above the fluid. By suspending the model in that vapor the aceton wil slightly 'melt' away the printing material and as such 'melt' away the print patterns without destroying the detail. I haven't tried this myself so please, please try this first on a scrap piece! 🙂
28 February 2018, 14:46
Patrick Hagelstein
Herstel bericht! I just looked at your pictures, is this a resin casting of the original 3D printed model? If so, the above won't work! That only works for the 3D printing material itself.... 🙁
28 February 2018, 14:48

Project info

5 képek
1:700
Ötletek
1:700 FREMM Carlo Bergamini F590 Frigate (Gwylan Models Gwylan001)1:700 Detail set Carlos Bergamini (Regia Marina AF097)

Összes album

Összes album megtekintése »