WIP - Tunguska/Tor Complex
Partially primed - first use of grey Stylynrez primer
Left set of guns/missiles ready
Working on right side
Added piece of 5mm brass tube to make sure it will align properly
Tracks with horns - a lot of work
Trying Puma turret
That's why I decided to buy Masterclub track to Tor
One wheel half was missing
And ready
I will cast copy
Copy done
Comparing with original
All wheels in complet
Doing suspension
Hozzászólások
5 13 February 2020, 18:31
Przemek PrzybulewskiStarted some time ago but it is hard to build it in one go.
Plastic is not too good - hard and tends to crack. A lot of seam lines. Myriads of small parts. Unclear instructions.
Will build it in the meantime of Su-25 and Faun.
Hard to clean all those tiny parts parts that see very well on this green plastic.
Most likely will be a lot to correct after spraying primer.
13 February 2020, 18:35
TreehuggerIt could be helpful cleaning the small parts when they are still on the sprue.
13 February 2020, 18:44
Przemek PrzybulewskiYeah, I tried this as well. I helps sometimes, but usually small parts are attached with tiny sprue pin. One bad move and they fly away like a sling shot 😉
13 February 2020, 18:52
