Novità
![](/profiles/img/user-s.jpg)
aggiunto un nuovo album fotografico.
55 immagini
MyAlbum![View album, image #4 View album, image #4](/albums/img/0/6/1/1671061-125353-38-720.jpg)
1:72
This picture is of BuNo 1063 - the subject I will be modeling. Very famous plane - was one of the ten JRS-1s that survi...
Progetto: Sikorsky JRS-1 (Eduard)
41 2 February, 15:21
![](/profiles/img/64707-255-s.jpg)
have to sit in...this is in the stash...I was looking at it yesterday...
25 February, 04:13
![](/profiles/img/user-s.jpg)
Thanks for following guys. Lochsa, you're right about the canopy. There are fit issues in general with this kit - most of which aren't too difficult to deal with - but the canopy is a bit of a mess. I'm not really looking forward to that part of the build.
25 February, 17:33
![](/profiles/img/user-s.jpg)
Thanks guys! Transall, it seems a lot stronger than the kit parts which were made from pretty thin plastic.
24 August, 00:56
![](/profiles/img/user-s.jpg)
Thank you Pietro! Still a long way to go. In the middle of priming the fuselage and having gap and other problems popping up. This is the build that never seems to end 🙁
25 August, 06:31
![](/profiles/img/user-s.jpg)
Thanks Gorby! This was my first time trying to scratch build landing gear. Took me probably 20 hours 🙁 I ended up using Albion Alloys brass tubing for a lot of it, along with music wire, copper wire, plastic tubing, and other materials. I've bumped it a few times already and it is very stable so fingers crossed it makes it to the finish line!
25 August, 14:48
![](/profiles/img/60714-348-s.jpg)
aggiunto un nuovo album fotografico.
27 8 November 2023, 21:10
![](/profiles/img/60714-348-s.jpg)
This project will have both pilots on the intercom and watching the engine startup process. That is why the same type figure is used in both cockpits. They both monitor the engine to ensure that the EGT and RPM is increasing appropriately. Each has their hand on the control stick to be able to open their MIC as they confirm everything is normal at start. The plan is to have the aircraft loaded with a Nuke (Apache Cruise Missile?). Seems appropriate to me for the days we live in now...
8 November 2023, 22:16
![](/profiles/img/28845-385-s.jpg)
Maybe go for resin seats as well?
Seems like kit plastic never can compete with resin seats. 🙂
Though, I no longer crave for resin interior for the cockpit because of the work, but seats are ok.
9 November 2023, 05:17
![](/profiles/img/60714-348-s.jpg)
I'll paint these up and see if I can tolerate them. If they are too bland, I have time to change my mind! Thanks for the idea!
9 November 2023, 21:25
![](/profiles/img/60714-348-s.jpg)
Great video of the weapon that goes with this version of the Mirage 2000N
Youtube Video
![](https://img.youtube.com/vi/eSznQrvjqJA/maxresdefault.jpg)
25 November 2023, 00:46
![](/profiles/img/60714-348-s.jpg)
As I have begun work on this kit, I am yet again struck by the lack of information in the variations and options provided in the kit. For example, the tail tip is not called out that applies to the 2000N version. While the nose of the 2000D is provided in the kit, it has to be modified to make it correct for the 2000N. Oh bother…
20 July, 02:40
![](/profiles/img/60714-348-s.jpg)
Selected "most appropriate" tail tip and mounted the correct nose to fuselage.
21 July, 20:04
![](/profiles/img/60714-348-s.jpg)
Okay, now I'm excited to get some paint on this cockpit!!! ResKit, you guys have done some great work with your 3D Resin Printing!
16 August, 18:29
![](/profiles/img/28845-385-s.jpg)
Oh, did you fiddle with the nose part to make it match the N version, or did you have to buy aftermarket nose for the N version? I have this kit in my stash, but haven't really looked any it yet.
28 August, 05:43
![](/profiles/img/60714-348-s.jpg)
I'm using the D nose but converting it to an N version. I'm also closing the "sucker doors" on the inlets to represent an engine that is not yet started... I'm assuming initial hydraulic power is applied from the APU and auxiliary hydraulic pumps have brought the gear door up. I'm going to close the speed breaks for pre-engine start configuration...
28 August, 17:36
![](/profiles/img/10306-948-s.jpg)
Looks like BAM has some corrected noses still need the N one. Maybe reach out to him. I could use the corrected nose for this kit also. The Reskit stuff looks amazing.
bam-models.com/produ..2000-corrected-nose/
30 August, 13:57
![](/profiles/img/60714-348-s.jpg)
Thanks for the heads up! The BAM nose looks fantastic! Sadly, the 2000N nose has a pitot tube and does not have the RDY antenna lines. It seems that much of the 2000N systems are somewhat earlier than the -5 systems. Everything I can find on the 2000N seems to be somewhat austere compared with the 2000-5. The ResKit cockpit is worth every penny!
30 August, 14:59
![](/profiles/img/141759-133-s.png)
Like it 😀👍
Nice when the pilot looks like he's actually doing something and engaged with the craft.
30 August, 15:22
![](/profiles/img/18633-333-s.jpg)
aggiunto un nuovo album fotografico.
6 3 January 2021, 12:25
![](/profiles/img/user-s.jpg)
WOW! That is some AMAZING work on the cockpit (even though you can't see it later!). Just knowing it is in there is inspiring!
Can't wait to get mine done!
29 August, 18:58
![](/profiles/img/141759-133-s.png)
Very nice start, nice aircraft..... designed to give the Soviet's one hell of a firework display.
👍👍
30 August, 15:20
![](/profiles/img/133058-903-s.png)
aggiunto un nuovo album fotografico.
3 immagini
Dutch B-339 Bufallo![View album, image #1 View album, image #1](/albums/img/0/0/9/1795009-133058-45-720.jpg)
1:48
cutting the mask, It is pretty tiring
Progetto: Dutch B-339 Bufallo
5 29 August, 17:17
![](/profiles/img/133058-903-s.png)
Yes, the paint should be different than the usual RAF dark green and brown scheme
30 August, 03:00
![](/profiles/img/133058-903-s.png)
I found few faults of this kit for fitting and few minor mold misalignments, probably due to how old the mold is. But nonetheless, it is still fun and few fixes wouldn't hurt.
30 August, 03:03
![](/profiles/img/43210-278-s.jpg)
It looks like a quite nice kit. Your masks look perfect. The buffalo I built was the matchbox 1/72 kit which isn't the best, but I built it when I was kid, so I wanted to see if I could do better this time
30 August, 15:06
![](/profiles/img/87178-578-s.jpg)
possiede questo oggetto
![1:48 Cassian Andor & K-2S0 (Fantasy Flight Games SWL59) SWL59](/products/img/1/4/5/1430145-74764-49-t180.jpg)
Cassian Andor & K-2S0 Star Wars Legion - Operative Expansion
Fantasy Flight Games 1:48
SWL59 2020 Nuovo stampo Argomento multiplo (2)30 August, 15:17
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=it
35
35
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo