Novità

Nik Watson
Good choice, these kits go together really well, enjoy that one 👍

Watto.

Christoph Kunz
Watching with interesst.
I've done one landing gear yesterday, very fiddly.

J35J
I'm in. Following👍🏻

Jakub Biganovsky
I am wondering how landing gear subassembly will fit; it will be next step.

Cuajete
Well done so far. Following!

Finn
I'm in

Łukasz Gliński
Joining the party

Robert Podkoński
Taking a seat.

Nicolas
Joining the fun.

J35J
The kit looks more "build friendly" than the DH88 Mikromir kit 1:48.
Looking forward to see the final result 👍🏻

Jakub Biganovsky
Yep, Clear props brough realy high level of plastic kits. They are not same level as Tamyia/Eduard or...., but still very high.
Nice fitting and approximate details make a building friendly. Some small part surfaces keep milling prints due to local missing polishing of mould, but still fine.

Michael Kohl
Following closely your progress as I have an eye on this kit. Nice additions you make and valuable experiences you share.

Guy Rump
Following. 👍

Cuajete
Good progress! 👍

Christoph Kunz
Thank you for your detailed buildlog.
I'm staying tuned.

Cuajete
Great (hard) job so far 👍

Kenneth
Following 😳

Michael Kohl
Fit of the wing halfes is a problem indeed (bought the kit in the meantime), but I think you chose the harder route. Sanding/scraping down the contact areas between the upper and lower wing halfes should solve the problem without the need for extensive use of putty afterwards.

Jakub Biganovsky
Michael Kohl, your recommendation could work. But, evidently not in my case.
Although that I thinned both halfs to try to fit them precisely as possible, a micro step was there after glueing halfs togther.
The gap between shorter lower and longer upper half was relatively big.
And the last think is, that lower and upper "profile" did not correspond to each other.