Novità
PanzerKnacker_76
vuole questo oggetto
vuole questo oggetto
Grilles for Panther Pz.Kpfw.V Ausf.A/D (ICM, Revell, Italeri)
Trembita Models 1:35
PE35002 2024 Nuovo stampo 15 October, 17:03
Rudy Poseika
possiede questo oggetto
possiede questo oggetto
PT-13/N2S-3 PT-17/N2S-5 Kaydet Primary Trainer for Revell
Starfighter Decals 1:72
72-158 2018 Nuovo stampo 15 October, 17:00
Sy Bar
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
36 immagini
Bf110C-6Nuovo: 15 October, 13:31 1:72
Underside complete, aerials left to do on upper surfaces
Progetto: Bf-110C-6
47 18 September, 11:53
Sy Bar
Was going to do the Battle of Britain version of this kit but I'm temped to have a go at some winter white wash and the wasp is cooler than the shark mouth 😎
Was going to do the Battle of Britain version of this kit but I'm temped to have a go at some winter white wash and the wasp is cooler than the shark mouth 😎
18 September, 11:56
István Szücs
I also have Bf-110 from the Airfix, I will build an Italian night fighter. The sprues are the same, so I'm watching!
I also have Bf-110 from the Airfix, I will build an Italian night fighter. The sprues are the same, so I'm watching!
18 September, 19:08
Sy Bar
Cheers guys.
I'm have a go at riveting, but going freehand as at this scale using tape was taking so long. I also not sure how much they will stand out on finish kit, but with the wonky line in parts they will probably bee seen from mars 🤣
Cheers guys.
I'm have a go at riveting, but going freehand as at this scale using tape was taking so long. I also not sure how much they will stand out on finish kit, but with the wonky line in parts they will probably bee seen from mars 🤣
22 September, 10:15
Sy Bar
Cheers #Guy 👍
#Skyhiker I found the fit to be good, I had a very slight gap at the front but think that was as much to do with me and the fitting of the pit (not the clearest instructions there). Every thing else was fine and the canopy was a good fit, I did change order of build slightly with the tail section I glued the rear piece to the body first then added the tail (after I'd added the stabilisers/rudders) this made more sense than the instructions 😁
Cheers #Guy 👍
#Skyhiker I found the fit to be good, I had a very slight gap at the front but think that was as much to do with me and the fitting of the pit (not the clearest instructions there). Every thing else was fine and the canopy was a good fit, I did change order of build slightly with the tail section I glued the rear piece to the body first then added the tail (after I'd added the stabilisers/rudders) this made more sense than the instructions 😁
24 September, 21:32
Sy Bar
Only issue I have with this kit are the decals. While they look great and are in perfect register, they have a large amount of film edging and are both thick and delicate at the same time🤪
Having a hard time getting them to settle into the panel lines etc. I usually just need to use micro sol but even ultimate extra strong is not have much effect. Going to have to wait till I get some Tamiya fixer, strong and extra strong hopefully one of these will help 🤞
Only issue I have with this kit are the decals. While they look great and are in perfect register, they have a large amount of film edging and are both thick and delicate at the same time🤪
Having a hard time getting them to settle into the panel lines etc. I usually just need to use micro sol but even ultimate extra strong is not have much effect. Going to have to wait till I get some Tamiya fixer, strong and extra strong hopefully one of these will help 🤞
24 September, 21:44
Mr D
You should be ok with the medium one with Airfix decals,
I like a mix of Water in with the markfix...seems to keep the decal floating longer.
I did the teeth on my p40 this way.
If they started getting bit sicky...l would add bit more water....keep it floating.
Wouldn't like to do shark teeth with HB decals 🤔🤣.... The lightning ⚡ strike on my mig-15 just fell apart with hardly any working.
Good luck with it ..look forward to seeing 😃👍👍
You should be ok with the medium one with Airfix decals,
I like a mix of Water in with the markfix...seems to keep the decal floating longer.
I did the teeth on my p40 this way.
If they started getting bit sicky...l would add bit more water....keep it floating.
Wouldn't like to do shark teeth with HB decals 🤔🤣.... The lightning ⚡ strike on my mig-15 just fell apart with hardly any working.
Good luck with it ..look forward to seeing 😃👍👍
27 September, 13:53
Sy Bar
Cheers for advice #Mr D. Afraid this set of decals were unaffected by all solutions but the mark fit super strong did have some effect. To make head way I found I needed to add the solution then after a few seconds apply hot air from a hairdryer to 'shrink wrap' the decal. These have to be the worst decals I've come across..
I recommend anyone doing this kit to source a set of decals rather than use those provided, they are not for beginners that's for sure. I hope the carrier film will disappear under a gloss coat but I didn't want to risk it so I've only applied the larger decals the smaller ones while add great detail if cartograf here they are 90% carrier film.
Cheers for advice #Mr D. Afraid this set of decals were unaffected by all solutions but the mark fit super strong did have some effect. To make head way I found I needed to add the solution then after a few seconds apply hot air from a hairdryer to 'shrink wrap' the decal. These have to be the worst decals I've come across..
I recommend anyone doing this kit to source a set of decals rather than use those provided, they are not for beginners that's for sure. I hope the carrier film will disappear under a gloss coat but I didn't want to risk it so I've only applied the larger decals the smaller ones while add great detail if cartograf here they are 90% carrier film.
28 September, 19:19
Skyhiker
Why don't you just cut the carrier film away with a knife before applying them?
Why don't you just cut the carrier film away with a knife before applying them?
28 September, 19:29
Mr D
Hi Sy
That's ok .... I think the result will be fine after a clear coat, you come out of it without wrinkles, bubbles or tear's so it's a win, very smart n be sorted under a clear.👌👍👍
Hi Sy
That's ok .... I think the result will be fine after a clear coat, you come out of it without wrinkles, bubbles or tear's so it's a win, very smart n be sorted under a clear.👌👍👍
28 September, 20:21
Sy Bar
Cheers #Mr D
#Skyhiker that's idea but life's too short for the amount there is, the size of the decal that's left will look like small black dots everywhere (especially the fuselage rib numbers 🤪); would be ok in 48 but too much in 72. Also I'm probably going to much it all up when I apply the winter white wash 😆
Cheers #Mr D
#Skyhiker that's idea but life's too short for the amount there is, the size of the decal that's left will look like small black dots everywhere (especially the fuselage rib numbers 🤪); would be ok in 48 but too much in 72. Also I'm probably going to much it all up when I apply the winter white wash 😆
29 September, 06:33
Sy Bar
Cheers folk for kind comments
The use of masking fluid has left too sharper mark contrast than I was looking for. I hope to try oils to soften the edges else I'll get the airbrush out again and go slow 😳
Cheers folk for kind comments
The use of masking fluid has left too sharper mark contrast than I was looking for. I hope to try oils to soften the edges else I'll get the airbrush out again and go slow 😳
2 October, 20:17
Sy Bar
Finally back to it, I don't know where the days/weeks disappear to. As ever the final "bits" take as much time as the main build.
The nervous removal of the canopy masking revealed no concerns so on with the lumps and bumps and wires…
Finally back to it, I don't know where the days/weeks disappear to. As ever the final "bits" take as much time as the main build.
The nervous removal of the canopy masking revealed no concerns so on with the lumps and bumps and wires…
14 October, 12:53
Mr D
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
3 15 October, 12:22
Mr D
Thanks Robert 😁👍
I've built few of these little guy,s there nice n easy n refreshing after bigger builds.
Thanks Robert 😁👍
I've built few of these little guy,s there nice n easy n refreshing after bigger builds.
15 October, 16:58
John
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
10 immagini
AFV Club F-16AMNuovo: 15 October, 16:56 1:32
Getting a start on this. The kit cockpit parts aren't terrible. May have to go back and redo the belts, never been a fan...
Progetto: ROCAF F-16AM Block 20 (AFV Club/Academy)
15 October, 16:56
AWAAAAAA
ha iniziato questo oggetto
ha iniziato questo oggetto
15 October, 16:49
Snake Plissken
Does your kit have the parts molded in dark green plastic? If so, you might need special glue because the plastic is not normal polystyrene; some say it might actually be ABS.
Does your kit have the parts molded in dark green plastic? If so, you might need special glue because the plastic is not normal polystyrene; some say it might actually be ABS.
15 October, 16:53
Lee Churchill
completato questo oggetto
completato questo oggetto
Sherman M4A4 75mm + Bonus DS Track + Bonus U.S. Tank Crew (NW Europe 1944)
Cyber Hobby 1:35
9102 (02) 2009 Nuove parti 15 October, 16:52
Michael Rotthowe
possiede questo oggetto
possiede questo oggetto
F-104S/F-104G Starfighter [Italian Air Force Fighter / Luftwaffe Fighter Bomber]
Hasegawa 1:72
D17 (00447) 2008 Nuova scatola 15 October, 16:50
simipe
vuole questo oggetto
vuole questo oggetto
Nakajima B5N2 Type 97 Carrier Attack Bomber (Kate) Model 3 w/Radar
Hasegawa 1:48
09423 2002 Nuove parti 15 October, 16:49
Kesa Tiho
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
1 immagini
A ship for my shipNuovo: 15 October, 16:49 1:700
Gotta love tamiyas posters
Progetto: A lil friend for my aircraft carrier
15 October, 15:01
simipe
vuole questo oggetto
vuole questo oggetto
Nakajima B5N1 Type 97 Carrier Attack Bomber (Kate) Model 1 '14th Flying Group'
Hasegawa 1:48
09525 2003 Nuove parti 15 October, 16:49
Snake Plissken
A strange hybrid kit. The Vietnam-era New Jersey on the box art is not what you get inside the box. The kit supplies parts that can depict a late WWII New Jersey with 20mm and 40mm AA guns, catapults and Curtiss Seahawks but includes a circa 1955-56 quadruped mainmast (rear mast) with AN/SPS-8 radar. It is therefore unique among the 1:350 Iowa-class models.
A strange hybrid kit. The Vietnam-era New Jersey on the box art is not what you get inside the box. The kit supplies parts that can depict a late WWII New Jersey with 20mm and 40mm AA guns, catapults and Curtiss Seahawks but includes a circa 1955-56 quadruped mainmast (rear mast) with AN/SPS-8 radar. It is therefore unique among the 1:350 Iowa-class models.
1 15 October, 16:48
simipe
vuole questo oggetto
vuole questo oggetto
Nakajima B5N2 Type 97 Carrier Attack Bomber (Kate) Model 3 'Folding Wing'
Hasegawa 1:48
09553 2004 Nuove parti 15 October, 16:48
simipe
vuole questo oggetto
vuole questo oggetto
Nakajima B5N2 Type 97 Bomber (Kate) Model 3 Coral Sea Torpedo Command
Hasegawa 1:48
09717 2006 Nuove decalcomanie 15 October, 16:48
simipe
vuole questo oggetto
vuole questo oggetto
Nakajima B5N2 Type 97 Carrier Attack Bomber (Kate) Model 3 'Zuiho Attacker'
Hasegawa 1:48
09761 2007 Nuove decalcomanie 15 October, 16:47
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=it
35
35
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo