Novità
Wayne Starick
possiede questo oggetto
possiede questo oggetto
RAN Fairey Gannet, AS Mk1 & T Mk2 HMAS Melbourne & RANAS Nowra, 1960's
Red Roo Models 1:48
RRD4875 2024 Nuovo stampo 11 August, 12:45
tairman-2
possiede questo oggetto
possiede questo oggetto
U-2C Canopy & Wheel Hub Masks
Cutting Edge Modelworks 1:48
CEBM48416 11 August, 12:44
Juergen Klinglhuber
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
29 31 May, 15:38
Juergen Klinglhuber
Started this one.
The Ju 86 which were seen in 2 different Austrian markings, but at the end was never part of the Airforce. Here the overall silver Ju86 #311 at the airshow in Vienna-Aspern in early 1937.
Started this one.
The Ju 86 which were seen in 2 different Austrian markings, but at the end was never part of the Airforce. Here the overall silver Ju86 #311 at the airshow in Vienna-Aspern in early 1937.
2 June, 11:10
Juergen Klinglhuber
The mention aircraft was sent to the Airshow in Aspern as a "demonstrator" in austrian marking. Austria was interessed in buying 18 Ju86K-7. Due to several reasons Junkers was not prepared for that airshow and on short note removed the markings of an 86K-2 that was already prepared to be sold to Sweden. They put on austrian markings, a service number #311 and flew it over to Austria for just this one day. Flight captain Behrendt did a good job and the aerobatic air-display was a great success. So far so good. Why I am telling this? 86-K2 is a differend engine and cowling. The box is a 86E1/2. Aftermarket conversion products are out there (Kora) .....I had difficulties to locate/buy some.
Therefore: it is Scratchbuilding time again !!! 😎
The mention aircraft was sent to the Airshow in Aspern as a "demonstrator" in austrian marking. Austria was interessed in buying 18 Ju86K-7. Due to several reasons Junkers was not prepared for that airshow and on short note removed the markings of an 86K-2 that was already prepared to be sold to Sweden. They put on austrian markings, a service number #311 and flew it over to Austria for just this one day. Flight captain Behrendt did a good job and the aerobatic air-display was a great success. So far so good. Why I am telling this? 86-K2 is a differend engine and cowling. The box is a 86E1/2. Aftermarket conversion products are out there (Kora) .....I had difficulties to locate/buy some.
Therefore: it is Scratchbuilding time again !!! 😎
5 June, 18:16
Juergen Klinglhuber
thx Alec &Lukasz for you very kind support 👍 - appreciated.
But the first cuts are already done - no way back now 😉
(and I have to odmit: usually I like it to test my skills by a DIY task every now and then)
thx Alec &Lukasz for you very kind support 👍 - appreciated.
But the first cuts are already done - no way back now 😉
(and I have to odmit: usually I like it to test my skills by a DIY task every now and then)
5 June, 18:51
Stefan Fraundorfer
Ah, a new and very interesting project. Of course I will follow that. Have fun with the Ju 86 Jürgen.
Ah, a new and very interesting project. Of course I will follow that. Have fun with the Ju 86 Jürgen.
15 June, 07:23
Juergen Klinglhuber
I have finished the modification on the engine resp. cowling. Some new pic's up-loaded.
I have finished the modification on the engine resp. cowling. Some new pic's up-loaded.
23 June, 15:27
Roland Sachsenhofer
Very interesting and extremely promising! We talked about it in Ried, and now I'm delighted to see these ideas being realised in such an impressive way!
Very interesting and extremely promising! We talked about it in Ried, and now I'm delighted to see these ideas being realised in such an impressive way!
23 June, 15:30
TH SCALE MODELS (Thomas Haberl)
Nice progress Jürgen! I´m in to see how this beauty comes together 👍
Nice progress Jürgen! I´m in to see how this beauty comes together 👍
24 June, 14:07
Juergen Klinglhuber
Thank you mates for leaving your nice comments.Iam wWorking on the exhaust pipe currently. New picture up-date should be ready after this coming weekend.
Thank you mates for leaving your nice comments.Iam wWorking on the exhaust pipe currently. New picture up-date should be ready after this coming weekend.
3 July, 17:07
Juergen Klinglhuber
All mod's are completted now - after adding the windows of the cockpit I can move it to the paint hangar.
All mod's are completted now - after adding the windows of the cockpit I can move it to the paint hangar.
13 July, 20:27
Juergen Klinglhuber
Hey - thank you Roland for your feedback. That gives motivation of course 🙂
Hey - thank you Roland for your feedback. That gives motivation of course 🙂
14 July, 16:01
Roland Sachsenhofer
That's great, that's how it should be, because your construction progress here gives me inspiration 🙂
That's great, that's how it should be, because your construction progress here gives me inspiration 🙂
14 July, 17:20
Juergen Klinglhuber
Thank you Alec, Thomas & Cuajete. When I had finished I thought: "Grab, overdone. This bird was for sure not that worn as it went to the airshow more or less fresh from the manufacturer." But the more looked at it the more I was okay with the result. So your comments are welcome and soothe my concerns. 👍
Thank you Alec, Thomas & Cuajete. When I had finished I thought: "Grab, overdone. This bird was for sure not that worn as it went to the airshow more or less fresh from the manufacturer." But the more looked at it the more I was okay with the result. So your comments are welcome and soothe my concerns. 👍
9 August, 16:22
Nicolas
Don't worry Juergen, even on new airplanes there are sometimes clear visual differences in the sheet metal. For example, some manufacturers deburr the rivet holes with a grinding machine, the sheets are made of different alloys or are applied with different rolling directions, all of which have an influence on the appearance. I like it.
Don't worry Juergen, even on new airplanes there are sometimes clear visual differences in the sheet metal. For example, some manufacturers deburr the rivet holes with a grinding machine, the sheets are made of different alloys or are applied with different rolling directions, all of which have an influence on the appearance. I like it.
9 August, 19:16
tairman-2
possiede questo oggetto
possiede questo oggetto
U-2C/F 'Interim' Seamless Intakes
Cutting Edge Modelworks 1:48
CEC48299 11 August, 12:43
tairman-2
vuole questo oggetto
vuole questo oggetto
U-2A/C Flying Control Surfaces
Cutting Edge Modelworks 1:48
CEC48319 11 August, 12:41
tairman-2
possiede questo oggetto
possiede questo oggetto
U-2R/S & TR-1A Seamless Intakes & Forward Landing Gear Bay
Cutting Edge Modelworks 1:48
CEC48442 11 August, 12:41
Thomas Kolb
aggiunto un nuovo album fotografico.
aggiunto un nuovo album fotografico.
47 immagini
Yak-12 - AmodelNuovo: 11 August, 12:38 1:72
Weathering applied with Tamiya Weathering Master pastel powders to make the model appear a bit dusty, scuffed and worn. ...
Progetto: Yak-12 - Amodel
32 5 July, 07:59
Łukasz Gliński
Me 3, I have to see that! Still procrastinating mine 😄
Thomas, are you considering getting rid of the decal with my support perhaps? 😉
Me 3, I have to see that! Still procrastinating mine 😄
Thomas, are you considering getting rid of the decal with my support perhaps? 😉
26 July, 20:14
Thomas Kolb
Łukasz, I am not going to use the provided decal sheet, so if you want it, just PM me with your address and I can post it.
Łukasz, I am not going to use the provided decal sheet, so if you want it, just PM me with your address and I can post it.
26 July, 21:48
Thomas Kolb
(And for everybody else with knowledge about the different versions of the Yak-12, yes, I am aware of the differences between the A-version in the kit and the R-version used by the Hungarian People's Army. But since I am not able to scratch build the entire wing and empennage structure, let's just call it artistic license.)
(And for everybody else with knowledge about the different versions of the Yak-12, yes, I am aware of the differences between the A-version in the kit and the R-version used by the Hungarian People's Army. But since I am not able to scratch build the entire wing and empennage structure, let's just call it artistic license.)
28 July, 11:08
Thomas Kolb
Thank you very much, dear gentlemen for your attention and encouraging words!
Thank you very much, dear gentlemen for your attention and encouraging words!
31 July, 14:48
Bruce Huxtable
Admiring your skills, and learning from your problem-solving, Thomas. Transforming an A-Model kit adds to the challenges 😉
Admiring your skills, and learning from your problem-solving, Thomas. Transforming an A-Model kit adds to the challenges 😉
4 August, 15:36
Thomas Kolb
Thank you Michael, Nicolas & Bruce for your interest and compliments! This kit is actually not quite as bad as some other Amodel kits I have built - the designers have created some pretty nifty solutions here! If anything, it is a bit unforgiving - make one small mistake and you can be sure that it will keep coming back to kick you.
Thank you Michael, Nicolas & Bruce for your interest and compliments! This kit is actually not quite as bad as some other Amodel kits I have built - the designers have created some pretty nifty solutions here! If anything, it is a bit unforgiving - make one small mistake and you can be sure that it will keep coming back to kick you.
5 August, 20:35
Bernhard Pethe
Wunderbarer Modellbau. Ich hab das Modell auch noch liegen und genauso wollte ich es auch machen. Mal sehen, wenn ich groß bin. 😉
Wunderbarer Modellbau. Ich hab das Modell auch noch liegen und genauso wollte ich es auch machen. Mal sehen, wenn ich groß bin. 😉
9 August, 16:24
Thomas Kolb
Bernhard, danke schön! 🙂 Ja, es ist ein ziemlich kniffliges Modell, aber es macht großen Spaß, es zu bauen!
Bernhard, danke schön! 🙂 Ja, es ist ein ziemlich kniffliges Modell, aber es macht großen Spaß, es zu bauen!
9 August, 17:17
Nicolas
Yes Thomas, I don't think you get any easy builds from Amodel. But with some work you get a nice and rare model. I realy like your progress. 👍
Yes Thomas, I don't think you get any easy builds from Amodel. But with some work you get a nice and rare model. I realy like your progress. 👍
9 August, 19:22
Thomas Kolb
Bruce, Lukasz, Cuajete, Nicolas, thank you! Yes, Amodel is actually cool in that they take a chance to make models outside the ordinary. Who else would design a model kit of a strange and ugly little high-winged Soviet aircraft instead of another Stuka, Tomcat or a Spitfire?
Bruce, Lukasz, Cuajete, Nicolas, thank you! Yes, Amodel is actually cool in that they take a chance to make models outside the ordinary. Who else would design a model kit of a strange and ugly little high-winged Soviet aircraft instead of another Stuka, Tomcat or a Spitfire?
10 August, 08:01
Thomas Kolb
Roland thank you mate! Cuajete, yes, this is the best gloss coat I have ever tried. It levels out to an absolute mirror shine (at least if it is applied to a perfectly smooth paint layer). This model ended up with a bit of orange peel effect at some places, so it is not absolutely perfect, but I can get away with it.
Roland thank you mate! Cuajete, yes, this is the best gloss coat I have ever tried. It levels out to an absolute mirror shine (at least if it is applied to a perfectly smooth paint layer). This model ended up with a bit of orange peel effect at some places, so it is not absolutely perfect, but I can get away with it.
10 August, 18:54
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=it
35
35
/it/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo