Bacheca

Christian Lehmann
@ Markus: Youre right, the fibres limit the number of LED´s and the small fibres enable to create small dots of illumination like at the turbo lasers . The small IC´s are responsible for flickering and the others at the large bord provide constant current of 20 mA like an electronic pre resitor. Iam not sure if they are really needed but after some try and error they helped to avoid damaged LED´s. I tried to keep it simple because I am also not that familiar with electronics. Power source is a battery pack with 3x1,5V=4,5V batteries and everything is connectet parallel so that each part gets the same voltage.

Markus Helmers
the small fibres were obvious to me, just unsure about the big ones, but that's not a bad idea at all. You can trick so much with electronics. I recently got some LED remotes off ebay for like 2€ each and while I wasn't sure they'd work at all, it turns out they're not only capable of dimming the LEDs, but also come with a bunch of premade effects that you can even adjust the speed of. I was very impressed with them.

Rui S
Great work allround 👍

CaptGPF
Very beautiful!

Rando
Isn't this Bossk's ship? I remember that name from my Tales of the Bounty Hunters book. Extremely cool project!

Christian Lehmann
@Rando: You´re right . I also put Bossk in the cockpit but unfortunately despite the large and plain windows illumination inside is poor. There are also one episode of "Clone Wars" where you can see this ship.

Christian Lehmann
I will try to light the engines bridge and some other areas. Because the kit is partly massive resin respectively fine 3D printed parts this will be a challenge.

Łukasz Gliński
Congrats
I think I have to go there since they give medals for OK Level builds 😛

Christian Lehmann
😂😂😂