BMD-1
The first challenge is cleaning the flash from the water intake grills under the hull.
The sprockets come in three parts, outer, middle, and inner. It is very difficult to get the outer ring (right) off the massive sprue without it breaking into tiny pieces.
The instructions don't tell you that the inner and outer rings can be lined-up to make the lightening holes. A lot of trial and error is needed to get the holes to line up!
Added weld beads at proper locations.
The plastic in this kit is very soft, scratches (and sands) easily and reacts with thinner, especially lacquer thinner which melts and distorts the surface.
Ready to paint!
Finally done! The individual tracks (with seperate, individual teeth) were a pain!
Commenti
14 November 2014, 19:30
Stefan Fraundorfer
Your BMD-1 looks good. Can you show more fotos from the finished model?
Your BMD-1 looks good. Can you show more fotos from the finished model?
12 December 2014, 14:18
Album info
Panda Hobby 1:35