AMG GT3 #46 LiquiMoly 12hr of Bathurst '20 (Job Log)
Body parts.
Assemble.
Using 'Green Putty' and cyanoacrylate.
White surfacer.
The side mirrors can now also be gripped with tongs. Viva Tamiya~ ^_^
Detail-Up
Ready for paint black surfacer.
Done.
And than, masking...
The carbon pattern was painted using stockings.
Close-up.
Gloss black surfacer.
I used 'Vallejo Mecha Primer' for this chrome plating part.
Remove masking tape.
ಠ_ಠ
Recovered.
Too rough pattern.
Apply 'Hasegawa Finish (Carbon)'
Start decaling.
The face was easier than I thought.
It was quite difficult here.
The adhesion of the offset decal was not good.
So I cut off the white area.
So I cut off the white area.
Black decal on the black?
I don't care. pass.
I don't care. pass.
The most difficult part of 'decaling'.
Done
Done.
Maybe last masking.
Easy seat belt tune-up.
Gloss clear coat and brush painting.
I used 'Tamiya Panel Line Accent'.
I used 'GSI Super Smooth Clear(Flat)'
It becomes a very luxurious matte finish.
It becomes a very luxurious matte finish.
Ready for assemble.
Start assemble.
I used sticker from the 'Bandai Pocket Mon' kit.
Assemble Cockpit.
Combine.
Pre-assembly of parts requiring rigidity
Assemble continue.
Assemble continue.
Assemble continue.
Pre-assemble for rear wing.
Metal sticker for mirror is best quality.
Tire decal is too glossy.
So I lowered the gloss.
Now than, attached every small parts.
Finally, attach the canard.
Finish.
Finish.
Commenti
6 3 January 2022, 13:51
Album info
motorart.tistory.com/380 (Korean)