Nanchang A-5C Pakistan

1
October 10, 2022
2
October 10, 2022
I used the brass cannon tubes from a Master Model set for the MiG-19.
3
October 10, 2022
Scratch built Radar Warning Receivers on the rear part of the tail. An addition on the Pakistani A-5C.
4
October 10, 2022
A tear drop shaped plate with the front RWR that was added to both sides of the fuselage. This was seen on many of my research photos.
5
October 10, 2022
All of the stores to be added to the wings & fuselage.
6
October 11, 2022
The A-5C is equipped with many Western parts including the ejection seat. Research says a MB seat. I found this resin seat in the parts bin and it definitely looks better than the kit part.
7
October 24, 2022
Resin seat installed and a new HUD added.
8
October 30, 2022
Almost finished the Reskit AIM-9P missiles. Only the clear seeker head needs to be added.
9
November 4, 2022
Canopy attached. Had to use a bit of Mr. Surfacer 500 to seal up gaps all around. Used Apoxie Sculpt to seal up the hole behind the canopy where a working “hinge” was to be placed.
10
November 13, 2022
I chose AK RC239 as the bottom color. Air Superiority Blue FS35450.
11
November 13, 2022
I did more pre-shading even though I fully intended to only do post-shading on this build.
12
November 19, 2022
The first upper color is applied. Tamiya’s XF-55 Deck Tan.
13
November 19, 2022
The second upper color is applied. Tamiya’s XF-58 Olive Green.
14
November 21, 2022
The final color is applied. Tamiya XF-68 NATO Brown.
15
November 27, 2022
16
November 27, 2022
Showing the added RWR on the back of the tail.
17
November 27, 2022
Bottom shot showing weapons.
18
November 27, 2022
Kit complete.

Commenti

81 10 October 2022, 23:53

Nathan Dempsey
After finding this kit nearly complete while unpacking my hobby room into my new house, I've finally been able to start working on it.

Thanks to Scott Head for his inspirational build here:
Nanchang A-5C 'Fantan' 1/48 | Album by yak23flora (1:48)

11 October 2022, 00:08

Maciej Bellos
Grabbing a seat!

11 October 2022, 02:39

John
Looks like you're off to a good start. 👍 The book "MiG Dynasty" has some excellent photos of the A-5C when operational with Pakistan.

11 October 2022, 03:59

Ben M
Cool subject! How's the kit?

11 October 2022, 04:05

James C
Following 👀 🙂

11 October 2022, 15:51

Nathan Dempsey
Thanks and welcome mates!

John: Thanks for the info. More photos are always useful.

Ben: This is a rather old tooling with very large panels and rivets. The main challenge was that the kit was tooled to have all the control surfaces functional but the fit of those surfaces left much to be desired and required many nights of putty/sanding sessions. Also the cockpit is non-existent. The rest of the main parts fit rather well though 🙂.

11 October 2022, 22:35

Villiers de Vos
Nice progress.

12 October 2022, 05:56

Nathan Dempsey
Thanks Villiers de Vos 🙂

Added a shot of my replacement ejection seat compared to the kit part.

12 October 2022, 16:18

Neil
Nice work Nathan 👍 I recently completed an AA Models kit also: Shenyang J-6, so have some knowledge of their kits - I have not done final photography. Obviously your work is more realistic than mine! 😉 Following this with great interest,

21 October 2022, 15:00

Nathan Dempsey
Thanks Neil! I know that the J-6 is a nearly identical kit and there are many of the same problems to solve.

I have been working on the cockpit and hope to have some new images up soon.

22 October 2022, 13:16

Chan Li
Aha!
I believe I saw this kit when I was at primary school, hopefully the assembly was smooth.
It's even hard for us to find this kit here…
No idea when it flew over Pacific over there, but with your hands the journey is worthy.
I'm following too.

22 October 2022, 16:15

Nathan Dempsey
Thanks and welcome to the build Chan Li.

Added an image of the cockpit. I should begin closing it up soon. You will also see some preshading as a first test of my new compressor and paint booth.

24 October 2022, 23:59

Nathan Dempsey
Some small advances this week. Attached the canopy and began work on the weapons.

4 November 2022, 00:22

Nathan Dempsey
Work has started on the paint. I have painted both the wheel wells & landing gear as well as the underside. I also did a bit more pre-shading on the upper surfaces.

13 November 2022, 20:33

Arif Saeed
Excellent work so far Nathan, liked it so much I purchased the trumpeter kit 👍

14 November 2022, 16:13

Nathan Dempsey
Thanks very much mates!

Arif: Hope to see your build soon!

19 November 2022, 16:03

Nathan Dempsey
Added a couple of images of the upper paint work.

20 November 2022, 18:24

Arif Saeed
Those Colors are spot on Nathan well done 👏

21 November 2022, 13:40

Nathan Dempsey
Thank you Arif 🙂

I now have the gloss coat applied ready for decals and panel lining.

23 November 2022, 13:57

Nathan Dempsey
Added shots of the completed kit. I see that I forgot to paint the running lights on the wing tips. 😂 I'll fix that soon.

27 November 2022, 22:42

alessandro magrelli
Nice subject and nice job! 👍👍

27 November 2022, 22:45

Arif Saeed
Awesome result Nathan looks excellent 👌

27 November 2022, 23:59

Chan Li
nice！A lot detailed paintings 👍

28 November 2022, 01:51

Villiers de Vos
Eye catching. You captured the Pakistani camouflage very well.

28 November 2022, 04:49

Neuling
Top notch. More pictures of the completed model would be nice!

28 November 2022, 09:40

Vincent
Very nice added details. Also great work on the camo scheme!!!

28 November 2022, 09:49

Nathan Dempsey
Thanks so much for all the nice comments and thanks for all the likes too!

29 November 2022, 20:50

James C
Very nice 👍

29 November 2022, 21:47

Rui S
Beautifully done 👍

29 November 2022, 21:50

Maciej Bellos
Looks great Nathan!

30 November 2022, 06:52

Nathan Dempsey
I'm overwhelmed by the positive response on this little build. Thanks again mates!

30 November 2022, 22:10

Dutch
Nathan, apologies for not following along on this one, but I am thoroughly enjoying the results! Beautiful work, brother! K/r, Dutch

18 December 2022, 16:57

Guy Rump
Very impressive. 👍

18 December 2022, 20:27

Nathan Dempsey
Thanks Dutch & Guy! Once I got past all the "moving parts" it was a fun build.

20 December 2022, 14:30

Slavo Hazucha
Nice job on a niche topic - turned out great and probably more realistic than on the over-saturated title pic - well balanced camo I think... It´s also cool to see how small game-changing details enhance the whole - here the cannon muzzles with very scale-matching appearance with the thin walls & all - things like this make the rest look more believable in an instant 👍

14 March 2023, 19:25

Maciej Bellos
Slavo, good to have you back! Sorry Nathan for spamming your nice build thread...

14 March 2023, 19:44

Nathan Dempsey
Thank you very much Slavo! This one was a big hit at the local club because no one knew what type of aircraft it was and also all their guesses as to the kit manufacturer were wrong. 😂

No problem Maciej! Nice to see Slavo back and building once more.

15 March 2023, 22:45

Michael Kohl
Beautiful result. I suppose some more pics will follow.

16 March 2023, 02:21

Clifford Keesler
Very nice. A unusual aircraft.

2 June 2023, 01:20

Nathan Dempsey
Thanks very much Michael & Clifford! Hopefully I'll take more pics at some point but my skill set is very poor in this area which is hilarious considering I have close family members who are professional photographers.

2 June 2023, 16:56