ニュースフィード

Gerald
Hello Welcome here 🙂

FiSe
Thank you 🙂

John
Cool! I was wondering how all the extra parts in mine looked when done, very nice. 👍

If you will accept a bit of advice, when you complete the cabin "shell" that goes into the fuselage halves, be prepared to do a lot of trimming and fitting before closing up. On mine, the sides of the fuselage wanted to push the roof of the cabin down and also hit the edges of the windscreen opening and that left a big gap on top. I finally got it acceptable fit, but even then, I wish I had cut more away because the cabin roof does not quite fit flush.

Qwertzel
Thanks for the advice. I'll take care of it 🙂
I build a lot of Revell kits in the past and the fitting was different with every model. I have got everything between pretty good and horrible. It's always like a mysterious box.

John
I'm sure you will do well with all that Revell experience. 👍 The good news is that other than the cabin shell, the rest fits OK (ish) even the windscreens. But if you want doors closed, also be prepared to do some surgery on them.

John
Looking good! 👍 Have fun with the main glass and fiddly rotor bits (I didn't 😄)

Qwertzel
Thanks, I will try my best

Guy Rump
Looking good, following. 👍

Andre Louis
Looking good indeed! How did (or will) you paint the inside of the air intakes?

John is right with his comment, the cabine ceiling is a problem. I decided to keep the pilot door frames on the inside out for the moment. Without them the fitting seems to be quite good.

Qwertzel
Thanks Andre! I already painted the air intakes with my airbrush. Now I will mask everything off so the paint is save for the yellow.

Skyhiker
This looks fun

Spanjaard
looking really good!

Robert Podkoński
The next Salamander? Taking a seat!

S M
Welcome, podkon! 😄 I have plenty of Salamanders to be built XD

Jan Peters
Joining Robert for this feast

Skyhiker
What does that aqueous black surfacer 1000 thin down with? Isn't aqueous a water based paint? Does it work well as a primer or does it peel off like the acrylic "primers"?

S M
I haven't tried to thin it with water although it is promised to work. I could airbrush mr.surfacer 1000 without thinning with my old 0,4mm needle airbrush, but in case I want to thin it I use Mr.Hobby Color Thinner 400 (turqoise colored bottle). I think this works very well as a primer. It sticks and it can be smoothed with sand paper.

Alberto
Nice work so far, watching! I also use aqueous black surfacer. I thin it 50% with Tamiya's X20A, spray it with a 0.4 mm needle at 15-17 psi. It works a treat.

Robin (WhiteGlint)
👀

Nicolas
Joining.

J35J
Swedish markings, I'm in on this project!

Skyhiker
Thanks for the info on the surfacer. I'm looking for alternatives to using heavy chemicals, and hopefully this will be an answer.

S M
Welcome, mates! 😄 @Skyhiker I just tried and it seems you can thin aqueous surfacer with water. I didn't paint anything with it yet.

Jan Peters
Nice progress, love the what if Swedish markings

Thomas Kolb
I am all eyes! Very cool indeed! I was initially quite baffled with the Swedish markings, the "what-if" went over my head.