ニュースフィード

Martin Oostrom
Dryfit the front window early in your build. I've heard rumours of a horrible fit near the engine intakes

Łukasz Gliński
Following

Thomas O'Eh
Thank you, Martin, for the input, I will keep it in mind!

Qwertzel
Following! I'm building a similar un 1:32. Good luck!

Alexey Bykov
check the rotation of main blades. in kit is made wrong side.
good luck!

Thomas O'Eh
thanks for the hint, Alexey. Will be tricky to fix this with the bent rotor blades. Have you seen any built where this was actually corrected?

Alexey Bykov
i made it =) karopka.ru/forum/forum260/topic24215/
you can bend blades in oposite side.

Gergő Takács
Thomas. I built this kit a few months ago. I used also lead as you mentioned. I squeezd it and choped it. I placed them under the cabinfloor and I put some inside of the dashboard cover also.

Mirko Römer
Following!

Thomas O'Eh
Thanks for all your advice, in the meantime I have continued on the details in the rear section and addressing the issue with the bad fit of the front window.

Ferenc Sarka
Following. I started the same kit last week. It will be a difficult one.
Good luck!

Alec K
Nice Ferrari, taking a seat. Není Laudova a ani z papíru, ale to určitě nevadí 😉👍

Jarda Malý
Laudovu mám ještě v zásobě, tohle je zatím rozcvička. Uvidíme jak to dopadne, obtisky jsou po těch letech na hovno a taky lesklá červená bude sranda😀

Alec K
Aha, tak to je správné 😂👍. Já auto nikdy nezkusil ale pro ty formule mám slabost. Ne tu červenou držím palce a těším se na pokračování. Motor je malej skvost 👍

George Williams
Great looking engine.

Jarda Malý
Alec K: díky. Ten motor bude nakonec zavřenej, nebude z něj nic vidět. Všecko je to jen pro ten pocit že to tam je😀 ale i tak natahám ještě pár káblíků.

Jarda Malý
George: thank you

Jakub Fiala
Rozjels to paradne. Motor vypadá luxusně 👍

Hugo Oliveira
I´m gonna follow this one.

Stéphane Jayet
nice engine

Jarda Malý
Thank you boys