RHAF WC54 Ambulance
![Album image #1 Album image #1](/albums/img/2/4/0/151240-12038-32-720.jpg)
Step one: Engine
![Album image #2 Album image #2](/albums/img/2/4/1/151241-12038-50-720.jpg)
A piece that supports the engine was missing from the chassis. Out of styrene fit, I made a replacement
![Album image #3 Album image #3](/albums/img/2/4/2/151242-12038-59-720.jpg)
Co-driver's seat needed adjastment
![Album image #4 Album image #4](/albums/img/2/4/3/151243-12038-10-720.jpg)
Tow hook was missing as well. I scratched one
![Album image #5 Album image #5](/albums/img/2/4/4/151244-12038-53-720.jpg)
The fuel nozzle is different from the real thing, so some alternations were needed
![Album image #6 Album image #6](/albums/img/2/4/5/151245-12038-74-720.jpg)
Some tape and wire, will represent a stretcher on one wall
![Album image #7 Album image #7](/albums/img/2/4/6/151246-12038-85-720.jpg)
Decontaminator or fire extinguisher, you choose
![Album image #8 Album image #8](/albums/img/2/4/7/151247-12038-37-720.jpg)
A bit of work is needed here as well
![Album image #9 Album image #9](/albums/img/2/4/8/151248-12038-12-720.jpg)
![Album image #10 Album image #10](/albums/img/2/4/9/151249-12038-12-720.jpg)
In the interior a lot of work took place. Pedals, window levers and door handles
![Album image #11 Album image #11](/albums/img/2/5/0/151250-12038-56-720.jpg)
I cut half of the hood, to have it half open, while I attached the opening levers on both sides. Τhe new dash is attached, the small co-drivers "table"as well
![Album image #12 Album image #12](/albums/img/2/5/1/151251-12038-17-720.jpg)
Off another Academy kit/set, I used a couple of gas cans, with some improvements
![Album image #13 Album image #13](/albums/img/2/7/0/151270-12038-68-720.jpg)
The door arches needed to be filled
![Album image #14 Album image #14](/albums/img/2/7/1/151271-12038-13-720.jpg)
The rear step was given in closed position. I need it open 😉
![Album image #15 Album image #15](/albums/img/3/1/8/151318-12038-49-pristine.jpg)
コメント
1 8 December 2014, 17:17
![](/profiles/img/12038-s.jpg)
Hey Gary, thanks. The saw I used here, is this -> Nano Saw set (RB Productions RB-T038, No)
8 December 2014, 18:19
![](/profiles/img/11091-s.jpg)
Nice work, I didn't know there were a lot of errors in the Academy kit.
8 December 2014, 19:43
![](/profiles/img/12038-s.jpg)
Thank you Dave. Unfortunately, for the vehicle I want to depict, there are issues.
8 December 2014, 22:25