wip
コメント
28 February 2018, 16:03
![](/profiles/img/15057-319-s.jpg)
Work in progress . I was very happy, now that I have a little time free after work to start this project. Putting aside the fact that the engine is larger than the inside diameter of the cowling and some putty will be needed for some area's, I see that I must put this project on hold .
First problem is that the wheels are moulded with spats , which need to be removed. This is not the end, I could come up with a solution . The worse part is that decals are missing the original writing of Bücker.
Photos with the progress will follow.
28 February 2018, 16:14
![](/profiles/img/27826-126-s.jpg)
Following. When you start, I would like to see how you solve all those problems, because I have the same kit. It will be interesing.
28 February 2018, 19:02
![](/profiles/img/15057-319-s.jpg)
Thanks for watching. Some of the problems are in the added photos, with the solution .
For engine I have chosen to thin the inner walls of the cowling with sandpaper, I did the same for the engine cylinder heads. As for the wheels either I shall copy half in resin or copy the entire wheel from another kit. Maybe from an Bücker 131.
1 March 2018, 16:27
![](/profiles/img/15057-319-s.jpg)
Welcome aboard Stefan. It will be a slow progress. There are many corrections to do and a lot of detail to add.
Thanks for stopping by.
1 March 2018, 19:39
Album info
Work in progress . I was very happy, now that I have a little time free after work to start this project. Putting aside the fact that the engine is larger than the inside diameter of the cowling and some putty will be needed for some area's, I see that I must put this project on hold .
First problem is that the wheels are moulded with spats , which need to be removed. This is not the end, I could come up with a solution . The worse part is that decals are missing the original writing of Bücker. Until I find a solution, I'll have to put it on hold.