EF2000 Single Seater
Cockpit ready...
Sanding...
More sanding.
Mr. Surfacer 1200 Primer
Mr. Surfacer 1200 Primer
Preshading...
Preshading...
Paint is done. Next is clear coat and decals.
Upper decals are set.
Lower decals are also set.
Panel lines are done. It’s time to get dirty.
Weathering and matt varnish done. Almost finished.
コメント
24 September 2019, 20:00
Yavuz Engin
Thank you mate but the fit is below average in my opinion. There are two big issues; first is canopy. There is a almost one millimetre gap between canopy and fuselage. I had to fill with evergreen and lots of putty. Second is nozzles. They are not flush through the body.
I build this kit to practice some weathering techniques. To be honest, unfortunately, it is waste of time.
Thank you mate but the fit is below average in my opinion. There are two big issues; first is canopy. There is a almost one millimetre gap between canopy and fuselage. I had to fill with evergreen and lots of putty. Second is nozzles. They are not flush through the body.
I build this kit to practice some weathering techniques. To be honest, unfortunately, it is waste of time.
6 November 2019, 07:47
Yavuz Engin
It comes to an end. I will release an separate album when it is finished.
It comes to an end. I will release an separate album when it is finished.
12 November 2019, 18:39