R35 GTR Pandem inspired
1
November 1, 20192
November 1, 20193
November 1, 20194
November 1, 20195
November 1, 20196
November 1, 20197
October 21, 2019I wanted a pannel line here but the 3D printed material did not allow the scriber to make a nice line in there so I had to redo it8
October 21, 2019interior is stock. I added some carbon here and there and the seatbelts9
October 21, 2019interior is stock. I added some carbon here and there and the seatbelts10
October 21, 2019in-between pic of the Factory81 engine. not done at all here11
October 21, 201912
October 21, 201913
October 21, 2019testfitting the engine to see where it had to be glued in. I also test fitted the turbos and it was quite a snug fit14
October 21, 2019this was the most horrible piece to work on. the body kit was rough but it was nothing compared to how this came out of the printer. it needed so much work to get smooth but when it finally did it was time for carbon15
October 21, 2019this was the most horrible piece to work on. the body kit was rough but it was nothing compared to how this came out of the printer. it needed so much work to get smooth but when it finally did it was time for carbon16
October 21, 2019this was the most horrible piece to work on. the body kit was rough but it was nothing compared to how this came out of the printer. it needed so much work to get smooth but when it finally did it was time for carbon17
October 21, 2019Test fitting the diffuser. really happy with it. it did not receive the clear coat at this point18
October 21, 2019Engine glued in19
October 21, 2019one of the harder bits to cover in carbon was the booth. I had to do it in 2 pieces to avoid folds and templates were quite hard to get right. In the end I pulled it off. Made me a carbon application pro. Everything is carbon on this car20
October 21, 201921
October 21, 2019trying out the thing with the climbing tape for heatshielding22
October 21, 2019and this was part of the end result23
October 21, 201924
October 21, 2019scratch making the hoses for the turbos and intercooler25
October 21, 2019Added the pannel line accent26
October 21, 2019completed the engine (before the body goes on and it gets more wires and the dry sump)27
October 21, 2019Making the dry sump system28
November 1, 201929
November 1, 201930
November 1, 201931
November 1, 201932
November 1, 2019Splittter and wheels on the car33
November 1, 2019All parts of this spoiler are 3D printed as well here it is all assembled ready to be glued to the body34
November 1, 2019spoiler and diffusor attatched to the car35
November 1, 2019Here it is finished. Enjoy36
November 1, 2019Here it is finished. Enjoy37
November 1, 2019Here it is finished. Enjoy38
November 1, 2019Here it is finished. Enjoy39
November 1, 2019Here it is finished. Enjoy40
November 1, 2019Here it is finished. Enjoy41
November 1, 2019Included this pooly lit pic to show off the exhaust42
November 1, 2019Here it is finished. Enjoy43
November 1, 2019Here it is finished. Enjoy
コメント
3 21 October 2019, 21:06