MS 410 build process

The exhaust pieces do not look good out of the box. I've filled the hole and will drill new ones with custom exhaust pieces. 

The front intakes were opened up on both sides. 

The small ducts were also opened up, though it does not show well on the picture. 

Very light scratchbuilding done on the interior, as this will be a closed canopy build and any excessive details would not be visible. 

I decided to model the elevators in the downward position to give the plane a little bit of interest. 

I modeled the large intake grill and purposefully printed it with a low quality (0,2mm layer lines). This way I achieved a convincing grill look and I don't need to worry about cleaning up the kit piece or glue residue. 

Scratchbuilt exhaust tips in place 

scratchbuilt exhaust tips 

coming together